PBv2.x Pen F/W Upgrade SOPWWPM_Brian Hung

2011/12/21

1.Plug the power cord 2.Press and hold the MENU key on keypad until all LEDs glow.

3.Connect USB cable plug in PB/Mouse mini B connector.

4. Use DLP composer to update new firmware (Please refer the following page.) 5. Unplug and plug power cord. 6. Execute Factory reset in service mode.(Push power->left->left->menu sequentially on keypad or remote control to enter service mode)

A. Main FW Upgrade

How to install and use DLP composer

1. Execute the setup file.

2. Follow all default setting to finish the installation process.

1. Execute the “Install DLP Device Driver” from start->Programs->DLP Composer™ Lite 10.5.1.

2. Choose all items and click install.(Please remove all external USB devices before installation)

1. Execute the “DLP Composer™ Lite 10.5.1” from start->Programs->DLP Composer™ Lite 10.5.1.

1. Click “Edit”->“Preference”

1. Click “Browse”

2. Choose the folder of FW

1. Choose USB

1. Click “Flash Loader”

2. Click “Browse”

3. Choose the correct FW file.(Please check the model name of projector before FW upgrade.)

1. Must follow the same setting as the picture.

2. Click “Start Download”

1. Click “Yes”

1. Wait for the upgrade process.

. Enter Service Mode (Push the button sequentially Power->left->left->Menu on keypad /remote control) or Power->Right->Right->Menu on keypad)

. Switch the USB mode from “Mouse” to “Debug” and do not close the OSD.

. Connect PC and projector via USB cable.

E. RF FW Upgrade (for UTi model)

1. Unzip RF FW.RAR

2. Execute DLP Pointblank Firmware Upgrade Tool.exe

3. Check the message as below “USB Connection Opened”

1. Execute the “Install DLP Device Driver” from start->Programs->DLP Composer™ Lite 10.5.1.

2. Choose all items and click install.(Please remove all external USB devices before installation)

2. Choose the correct FW file

1. Click “Browse”

3. Click Download

4. Reboot the projector after upgrade process finish.

. Enter Service Mode (Push the button sequentially Power->left->left->Menu on keypad /remote control) or Power->Right->Right->Menu on key pad)

. Execute “Factory Reset”

. Reboot the projector

Tips. Turn on the PB function of the projector and pen.. Make sure the connection is workable.. Change the Channel setting from “Auto” to any other number.