op com setup instruction

1. create a folder named [op-com] at the desktop.

2. open [op-com] CD.

3; set up “op-com EN exe”.

www.chinasinoy.com

Email:[email protected] MSN:[email protected]:cnsinoy

4. Destination folder (Please select the folder, in which OP-COM will be installed), here youselect the blank folder “op-com” you just now created in the desktop.

www.chinasinoy.com


www.chinasinoy.com


5. open “op-com” folder in your desktop.

www.chinasinoy.com


6. Open the CD and copy the “OPCOM090714_EN_Crack.exe”, then paste them into the folder of“op-com” in the desktop.

www.chinasinoy.com


6 .connect op-com interfaces to your PC, then it will tell you to setup op-com driver, please selectthe second option and click “Next”.

7, select the destination folder for driver setup.

www.chinasinoy.com


www.chinasinoy.com


8. finish setup driver, now check op-com driver location “My computer=management= devicemanagement=USB”, if op-com driver location shows as follows, that means it is ok now.

www.chinasinoy.com


9. Open “OPCOM090714_EN_Crack.exe” under the folder of “op-com” on the desktop, ready toactivate software. Com not found, because the software is not activated.

www.chinasinoy.com


10. Click “Settings”.

11. Click “test interface”, run activation program.

www.chinasinoy.com


12 activation program runs well and get Serial Number, “Save Config”, “close” Serial Number.

13. Select “diagnostics”.

www.chinasinoy.com


14. select protocol to diagnosis.

www.chinasinoy.com


15. pass the protocol, select “diagnose ECM”.

16. Read fault codes.

www.chinasinoy.com


www.chinasinoy.com


op com setup instruction

Documents