msds galva flux sti.pdf

7/25/2019 MSDS GALVA FLUX STI.pdf

http://slidepdf.com/reader/full/msds-galva-flux-stipdf 1/5

521/522, 2nd Floor, Solitaire Corporate Park, Bldg. No. 5, Andheri Ghatkopar Link Road, Chakala Andheri (E),

Mumbai – 400093, India. Tel: +91 22 42144545/+91 22 28215995 | Fax: +91 22 28302612

www.shreetechinternational.com

Dated : June 2016

MATERIAL SAFETY DATA SHEET

SECTION 1 :IDENTIFICATION OF THE MATERIAL AND SUPPLIER

Product name : GALVA FLUX STI

Other names PREFLUX /WATER FLUX

Recommended use :As a Flux for GALVANIZING

Manufacturer & supplier.

SHREE TECH INTERNATIONAL :Tel no :0091-22-28215995/28344604521/522 Solitaire corporate Park :Fax 0091-22-28302612

BLDG NO 5. Chakala Andheri East

Mumbai 400 093 IndiaPRODUCT INFORMATION PHONE :0091-22-42144545

SECTION II :HAZARD IDENTIFICATION.

Emergency overview

CAUTION: CAUSES IRRITATION TO SKIN , EYES AND RESPIRATORY TRACT

Health rating 1 Slight

Flammability rating :0 – None

Reactivity Rating :1 – Slight

Contact rating :2 Moderate

protective equipment :Goggles, vent hood , proper glovesInhalation: Inhalation of the dust may cause irritation to respiratory Tract. Excessive contact isknown to cause damage to Nasal Tract.

Ingestion: Toxic effects described in animals due to short exposure include corrosion of mucous

surfaces.

Human Health effects of overexposure by Inhalation , ingestion or skin or eye contact mayinitially include eye irritation , tearing or blurring of vision. Skin irritation with discomfort or

Rash or irritation of upper respiratory passages. Individuals with preexisting diseases of the lungs

may be having increased susceptibility to the toxicity of excessive exposure.Eye contact :contact may be corrosive to eyes..

SECTION III : COMPOSITION & INFORMATION ON INGRADIENTS.

CHEMICAL CHARACTERISTICS :

MIXURE:

Ammonium Chloride : 40% to 50%

Zinc Chloride : 50 % to 60%






Non Hazardous Additives :10%

CAS NO of INGRADIENT : NH4Cl :12125-02-9

SECTION IV : FIRST AID MEASURES.

Inhalation:remove to fresh air .if not breathing give artificial respiration .if breathing isdifficult give oxygen.Get medical attension.

Ingestion: If swallowed do not induce vomiting .give large quantity of water .Never giveanything by mouth to an unconscious person.Call physician immediately.

Skin contact: Immediately flush skin with plenty of water.. remove contaminated

clothing. Call physician immediately.

Eye contact: Immediately flush with plenty of water for atleast 15Mins, lifting lower &upper eyelids occasionally.Get medical attention immediately.

SECTION V :FIRE FIGHTING MEASURES.

Fire : Not considerd a fire Hazard.

Explosion: Not considerd a explosion hazard. May release zinc oxide , ammonium

chloride fumes & ammonia & hydrogen chloride gases at very high temperatures.

Existinguishing media: As appropriate for combustibles in Area.

Special Fire fighing instructions: None

Fire Fihgting Procedure: Wear self contained breathing apparatus & protective clothingto prevent contact with skin & clothing.

Flammable limits in air.% by Vol : Not applicable.

Lower : Not applicable.

Upper :not applicable.

SECTION VI: ACCIDANTAL RELEASE MEASURES

Emergency measures:Remove all sources of ignition.Ventillate area of leak orspill.Wear appropriate personal protection equipment as detaled in Section 8.

Method of material containment and cleanup: Clean up in a manner as not to dispersedust into air.

Do-not allow material to be released to the environment without proper government

permits.

Addional information:

Keep unprotected persons away.

See section 7 for information on safe handling.

See section 8 for information on personal protective equipment.

See section 13 for disposal information.

SECTION VII :HANDLING & STORAGE Keep packing tightly closed.

Store in cool ,dry place in tightly closed containers. Ensure good ventilation in work place.

Do-not store in Mild steel or aluminium containers.

Store away from oxidising agents.

Protect from exposure to light.






No special requirement for Storerooms.

Keep ignition sources away.

SECTION VIII : EXPOSURE CONTROL & PERSONAL PROTECTION:NOT LISTED AS HAZARDOUS MATERIAL :

AIRBORNE EXPOSURE LIMITS :

No DataBiological Limit values:

No DataENGINEERING CONTROLS : A system of local & general exhaust is recommended to keep

employee exposure below the airborne exposure limits. Local exhaust Ventlillation is generally

preferred because it can control emission of the contaminant at its source ,preventing dispersion

of it into general work area,Personal protective equipment :

Personal respirators (NIOSH APPROVED) :For conditions of use where the exposure tothe dust or mist is apparent a half face dust/mist respirator may be worn.For emergencies

or instances where the exposure levels are not known use a full face positive pressure ,airsupplied respirator.

Skin protection: wear protective gloves & clean body covering clothing.

Eye protection:Use chemical safety goggles and or full face shield where dusting or

splashing of solution is possible.

Maintain eye wash fountain & quick drench facilities in work area.

SECTION IX PHYSICAL & CHEMICAL PROPERTIES

Appearance :Greenish whitish Crystalline Powder

Color : Greenish white

Odour :Characteristic

pH : 4 in acqueous solutions.

Vapor pressure :Not determined

Vapor density :Not determined.

Boiling point /Range >600ºC

Melting Point / : 300º C

Solubility in water :100%

Specific Gravity :2.10

Information on Flammable material : Not a Flaamable material

Additional information:Not Inflammable & not a FireHazard. Flash Point :No data

Percent Volatile by Vol : 0

Evoporation Rate :No data

Evoporation Standard : No data

Auto Ignition Temp :Not available

Lower Flammability limit in Air: Not available.






Upper Flammibility Limit in Air :not available.

SECTION X :STABILITY & REACTIVITY

Chemical stability :stable Conditions to Avoid: Moisture, Dusting

Mateials to avoid :potassium cyanide , acids , alkalies.

Hazardous decomposition products: Oxides of Zinc , Hydrogen Chloride , ammonia Nitrogen Oxide

Hazardous polymerization :will not occur.

SECTION X1 :TOXICOLOGICAL INFORMATION

Primary irritant effect

On the skin: Irritant to skin & mucous membraines.

On the eyes: Irritating effect.

Sensitization: No sensitizing effects known

No mutazenic effects have been observed on tests with laboratory animals.

Additional toxicological information:To the best of our knowledge the acute & chronic toxicityof this substance is not fully known..No classification data on carcinogenic properties of this

Material is available from EPA,IARC ,OSHA Or ACGIH.

SECTION XII: ECOLOGICAL INFORMATION

ECOTOXICITY :Not Available.

Persistance & degradability :No Data available.

Mobility :No data availabe

Enviornmental exposure : No data available. Bioaccumulative potential ;No data available.

General notes: Do-not allow material to be released to the envionrment without proper

govt permits.

SECTION XIII : DISPOSAL CONSIDERATION:

Reccommended methods for safe & enviornment friendly disposal :Whatever cannot be saved forrecovery or recycling should be managed in an approved & appropriate waste disposal

facility.Processing ,use or contamination of this product may change the waste management

options.dispose of containers & unused contents in accordance with federal , state & localrequirements.

SECTION XIV :TRANSPORT INFORMATIONS:

Not a hazardouse material for transportation.

DOT regulations

Hazard Class :none






Land transport ADR/RID (Cross border)

ADR /RID class :None.

Maritime transport IMDG

IMDG class :noneAir transport ICAO-IT & IATA – DGR

ICAO/IATA Class :NoneTransport /Additional information

Not dangerous according to the above specifications.

SECTION XV :REGULATIONS.

Product related hazard information.

Hazard symbols: Xn harmful.Risk phrases :

37 irritating to respiratory system

Safety phrases:

36/37Wear suitable protective clothing & gloves.Information about limitation of use:

For use only by technically qualified individuals.

SECTION XVI :INFORMATION.

Employers shoud use this information only as a supplement to other information gathered by them

and should make independent judgement of suitability of this information to ensure proper use and protect the health & safety of employees. This information is furnished without warranty and any

use of this product not in conformance with this material safety data sheet , or in combination with

any other product or process , is the responsibility of the user.

DEPARTMENT issuing MSDS : Lab, Health ,Safety & enviorment department .

Contact :P.N.MENON (CEO) SHREE TECH INTERNATIONAL.

521/522 Solitaire corporate Park , Bldg no 5Chakala , Andheri (E) Mumbai 400 093 India

Shelf Life :18Months

msds galva flux sti.pdf

Documents