model n° 1270 owner’s manual copy...instruction #1067168 d 10/21/2013 copy 3 most injuries are...
TRANSCRIPT
Keep this Product ID Number and use when contacting Customer Service:
OWNER’S MANUAL
MODEL N° 1270
COPY
2
Save this owner’s manual for future reference and in the event that the manufacturer has to be contacted.
REGISTER YOUR PRODUCT ONLINE AT WWW.LIFETIME.COM
At Lifetime, we are committed to providing innovative and quality products. While registering, you will
have the opportunity to give us your feedback. Your input is valuable to us.
Lifetime’s Promise to You:
REGISTER today!
**U.S. and Canada customers ONLY**
DO NOT CONTACT THE STORE!CALL OUR CUSTOMER SERVICE DEPARTMENT at
1 (800) 225-3865
Questions or Missing Parts? ID:
INSTRUCTION #1067168 D 10/21/2013
COPY
3
Most injuries are caused by misuse and/or not following instructions. Use caution when using this product.
FAILURE TO FOLLOW THESE WARNINGS MAY RESULT IN SERIOUS INJURY OR PROPERTY
DAMAGE AND WILL VOID WARRANTY.
SAFETY INSTRUCTIONS
BEFORE BEGINNING ASSEMBLY
4
TOOLS AND PARTS REQUIRED FOR THIS ASSEMBLY
*Two adults required to
complete assembly*
Only adults should set up the product. Do not allow children
in the setup area until assembly is complete.
Adjustable Wrench
Phillips Screwdriver
Funnel
7/16” Wrench
Scrap Wood
Sand
Pliers
Rubber Mallet
1/2” Wrench
Water Hose
3/8” Socket Wrench
3/16” Allen Wrench
5
This area is located at the top,
left-hand corner of the page
and indicates which tools
and hardware are needed to
complete the assembly steps
on a page.
Note:!
Refer to the following areas throughout the instructions
to assist in the assembly process:
This area is usually located in the
bottom, left-hand corner of a step
and indicates that special attention
is needed to perform a particular
part of a step.
These areas are usually located in
the bottom, right-hand corner of a
step and indicate that damage to
the product or serious injury may
occur if the caution or warning is
not heeded. WARNING
ASSEMBLY GUIDES
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
CAUTION
6
PARTS LISTID Item Description Qty
HARDWARE LISTID Item Description Qty
BCO Pole Assembly Hardware
BCQ Pole to Base Assembly Hardware
BCR Backboard to Pole Assembly Hardware
7
Parts shown at 10% of Actual Size
ALH
ALF
ALE
PARTS IDENTIFIER
AJJ
AJK
AJC
15 ”3/4 7”AJE
*Warning Sticker applied to side not shown
ALI
*Do not remove Top Pole from Middle Pole until instructed
ALX
AKZ
8
Parts shown at 5% of Actual Size
PARTS IDENTIFIER
AJI AJM
AYU
AMU
AEF
Part shown at 25% of Actual Size
CIH
Parts shown at Actual Size
AOX
9
HARDWARE IDENTIFIERPOLE ASSEMBLY HARDWARE [BCO]Hardware shown at Actual Size
ADSAAN
AYT
AOL ABD
ABN
BACKBOARD TO POLE ASSEMBLY HARDWARE [BCR]Hardware shown at Actual Size
POLE TO BASE ASSEMBLY HARDWARE [BCQ]Hardware shown at Actual Size
AAE
AAOBTS
ABD
CII
APG ABD
CCL
10
HARDWARE IDENTIFIER
BACKBOARD TO POLE ASSEMBLY HARDWARE (CONTINUED)Hardware shown at Actual Size
ADQ
APK
APN
AACABK
11
POLE ASSEMBLY
HARDWARE REQUIRED
PARTS REQUIRED
TOOLS REQUIRED
SEC
1
Parts shown at 10% of Actual Size
Phillips Screwdriver
Hardware shown at Actual Size
Scrap Wood
ALH
ALF
ALE
*Warning Sticker applied to side not shown
ADS
AAN AYT
AOL
ABD
AYU
*Do not remove Top Pole from Middle Pole until instructed
1/2" Wrench
CIH
Part shown at 25% of Actual Size Part shown at Actual Size
BCO
12
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
Top Pole (ALH) Middle Pole (ALF)SEC
1.1
Note: Make sure the crimped side of the Top Pole is on the same
side as the Warning Sticker (AMT) on the Middle Pole.!
ALH
Warning
Sticker
ALF
NO TOOLS OR HARDWARE REQUIRED FOR THIS PAGE
13
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
Top Pole (ALH) Middle Pole (ALF)SEC
1.2
1/2”
AAN
AOL
ABD
WARNING
ALH
ALF
AOLABD
AAN
14
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
Middle Pole (ALF) Bottom Pole (ALE)
1/4” x 3/4” Screw (ADS)
Domed Countersink Washer (CIH)
SEC
1.4
ADS
Note: The 1/4” x 3/4” Screw should be fl ush with the Pole, but will spin
freely once installed. Do not jam the Poles together until instructed.!
ALE
ADS
ALE
ALFALF
SEC
1.3
CIH
15
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
Bottom Pole (ALE)
Middle Pole (ALF)
NO HARDWARE REQUIRED FOR THIS PAGE
Scrap Wood
ATTENTION: THIS STEP CANNOT BE REVERSED!
DO NOT COMPLETE ASSEMBLY.
Note: Do not hit your feet with the Pole sections,
as serious injury could occur.!
WARNINGThe Poles must be seated together! Even if the Poles cover
the slots before seating, they must be struck on a hard
surface fi ve to six times! Failure to seat the Poles correctly
could allow the Poles to separate during use, which could
lead to serious personal injuries or property damage.
ALE
ALF
ALH
SEC
1.4
SEC
1.4
16
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
SEC
1.55/16” Hex Nut (AYT) 5/16” Hex Knob (AYU)
5/16” x 3 1/4” Carriage Bolt (AOL)
Top Pole (ALH)
Middle Pole (ALF)
AYTAOL
NO TOOLS REQUIRED FOR THIS PAGE
ALH
ALF
AYUAOL
AYU
AYT
17
AJM
ALI
AJC
AMU
15 ”3/4 7”AJE
Parts shown at 10% of Actual Size
Part shown at 25% of Actual Size
POLE TO BASE ASSEMBLY
HARDWARE REQUIRED
PARTS REQUIRED
TOOLS REQUIRED
SEC
2
Part shown at 5% of Actual Size
Hardware shown at Actual Size
ABN
AAE
AAO
BTS
ABD
1/2" Wrench
CII
CCL-3/16” Allen Wrench
BCQ
CCL (x2)3/16” Allen Wrench
18
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
ALI
AAE
ABDAJM
ABDAAO
AAE
ABDABN
AAO
NO TOOLS REQUIRED FOR THIS PAGE
Pole Brace (ALI) Base (AJM)SEC
2.1
Note: Repeat this step to install the other Pole Brace to
the other side of the Base.!
1/2” x 15 3/4” Axle (AJC) Wheels (AMU)
Bottom Pole (ALE) 1/2” x 7” Axle (AJE)
1/2” x 1/8” Spacers (ABN)
SEC
2.2
AJCABN
ABN
AMU
AMU
AJC
ALEAJE
19
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
Top Pole (ALH) 1/2” x 15 3/4” Axle (AJC)
Base (AJM)
1/2” x 7” Axle (AJE)
SEC
2.3
BTS
1/2"
CII
Pole Braces (ALI) Bottom Pole (ALE)SEC
2.4
Note: Tip the system forward so the Pole rests on the ground. Do not stand
the system up until it is fi lled with either sand or water later in the assembly.!
AJC
AJM
AJE AJM
BTS CII
ALE ALIALI
3/16"
20
BACKBOARD TO POLE ASSEMBLYSEC
3
Hardware shown at Actual Size
HARDWARE REQUIRED
APG
AAC
ABDADQ
APK
ABK
APN
BCQ
21
BACKBOARD TO POLE ASSEMBLYSEC
3
PARTS REQUIRED
ALX
Parts shown at 10% of Actual Size
Part shown at 5% of Actual Size
1/2” Wrench
TOOLS REQUIRED
AJI
AJJ
AJK
3/8” Socket Wrench
AOX
Part shown at 25% of Actual Size
22
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
3 1/2” U-Bolt (APK) Left and Right Backboard Brackets (AJJ
& AJK)
Left and Right Backboard Brackets (AJJ & AJK) Top Pole (ALH)
SEC
3.1
SEC
3.2
1/2”
APK
AJJ
AJK
APKNotch
APK
APG
APN
AJJ
AJK
APG
APG
APNAPN
AJI
AJK
ALH
23
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
1/2”
Rim (ALX) Backboard (AJI)
Rim Support Channel (AOX)
3 1/2” U-Bolt
(APK)
5/16” Washers (ABD) 5/16” Nylock Flange Nuts (ABK)
SEC
3.3
5/16” x 3 1/4” Hex Bolts (AAC) 5/16” Washers (ABD)
5/16” Nylock Flange Nuts (ABK).
AAC
ABDABK
AOX
AAC AACABK
ABKABD
ABKABK
APK
AJI
ALX
ABD
24
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
Left and Right Backboard Brackets (AJJ & AJK)
Backboard (AJI)
SEC
3.4
ADQ
3/8”
ADQ
ADQ
AJI
AJJ AJK
25
FINAL ASSEMBLY
HARDWARE REQUIRED
PARTS REQUIRED
TOOLS REQUIRED
SEC
4
Part shown at 10% of Actual Size
NO HARDWARE REQUIRED FOR THIS SECTION
AKZ
AEF
Funnel
Sand
Water Hose
Part shown at Actual Size
26
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
NO HARDWARE REQUIRED FOR THIS PAGE
SEC
4.1
Two adults are required to complete assembly. To prevent serious injuries, the
Pole should be held down by one adult at all times while the Base is being fi lled.
OPTION A: FILLING WITH SAND
Base Plug (AEF) Base (AJM)
WARNINGFor safety reasons, we recommend that sand be used
instead of water to fi ll the Base. If a leak develops, water
could run out unnoticed, allowing the system to fall over,
resulting in serious personal injuries, or property damage.
If using Water, check the Base carefully for leaks. If a
leak is found, lay the system down on the ground and
call Customer Service. Do not use, stand up, or play on
a leaking system.
AEF
AJM
27
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
AEF
AJM
NO HARDWARE REQUIRED FOR THIS PAGE
SEC
4.1
Two adults are required to complete assembly. To prevent serious injuries, the
Pole should be held down by one adult at all times while the Base is being fi lled.
OPTION B: FILLING WITH WATERBase Plug (AEF) Base (AJM)
28
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
SEC
4.2
ALX
AKZ
Net (AKZ) Rim (ALX)
Note: If a replacement Net is needed, please call our Customer Service Department.
Our Nets are shorter than average to reduce the risk of entanglement.!
NO TOOLS OR HARDWARE REQUIRED FOR THIS PAGE
29
To Raise or Lower the Hoop:
OPERATION OF HEIGHT ADJUSTMENT SYSTEM
WARNING:
CAUTION:
MOVING THE SYSTEM
30
IF RUST HAS PENETRATED THROUGH THE POLE ANYWHERE, REPLACE IT IMMEDIATELY!
POLE CARE AND SYSTEM MAINTENANCE
31
NOTES
32
NOTES
33
NOTES
34
ENHANCE YOUR LIFETIME® PURCHASE BY ADDING
ACCESSORIES OR OTHER GREAT PRODUCTS:
Or call: 1-800-424-3865
To purchase accessories or other Lifetime Products, visit us at:
www.lifetime.com
35
FAUTE DE NE PAS SUIVRE CES AVERTISSEMENTS, VOUS RISQUEZ DE CAUSER DES BLES-
SURES GRAVES ET/OU DES DOMMAGES À L’ÉQUIPEMENT.
SI NO SE OBEDECEN ESTAS ADVERTENCIAS PUEDEN PRODUCIRSE GRAVES LESIONES Y/O
DAÑOS A LA PROPIEDAD.
FAILURE TO FOLLOW THESE WARNINGS MAY RESULT IN SERIOUS INJURY AND/OR
PROPERTY DAMAGE.
#FS16400 10/12/2004 www.lifetime.com
WARNING
ADVERTENCIA AVERTISSEMENT
36
LIFETIME BASKETBALL EQUIPMENT5-YEAR LIMITED FACTORY WARRANTY
THE MANUFACTURER RESERVES THE RIGHT TO MAKE SUBSTITUTIONS TO WARRANTY CLAIMS IF PARTS ARE
UNAVAILABLE OR OBSOLETE.
ALL WARRANTY CLAIMS MUST BE ACCOMPANIED BY A SALES RECEIPT.
REPORT PRODUCT DEFECTS IN WRITING TO:
To register the product, visit our Web site at www.lifetime.com
WARRANTY INFORMATION
www.lifetime.com