mig-29 pe detail parts - coldwarstudio.com
TRANSCRIPT
First you have to prepare the plastic parts of the kit where the PE will be mounted.Some parts are double layers, some are single layers and in most cases the largepanels are flush with the surface. So a bed for the parts should be done after dry fitting of these parts. I used a motor tool, you may have your proffered method.I will mark in green the parts that should be flush with the surface.
PE PE
Make bed in plastic
Plastic Plastic
This is example how to form the louvreswith the help of a toothpick. Use this method on all necessary parts.
AIR INTAKESThe ramps are closed only with running engines on the ground and the LERX louvres open. With engines shut or in flight theyare open.The PE ramps are applicable to both the kit intakes or to the Zacto intakes.
CWSPE32008
Cold War Studio2021
MiG-29 PE Detail Parts For the Revell kits in 1/32 scale
Zacto intake Revell intake
4039
View in profile of the ramp
Left Air Intake
Make openings
Glue the armament safety switch in opening.It is open when the aircraft is armed.This is the last thing the maintenancecrew closes before taxi.
Armament safety switch
Wire or plastic rod
47
48
47
CWSPE32008
APU and surroundings
20
19
8b
Fold to make thefuel drain
Make 2
24
15
16APU Door
55
44
23
43
1820+19
8a
8b
25
26Fill
Cut open
24+15+16
CWSPE32008
4 5
6
7
35a+35b
34a+34b
41
plasticPE 34a or 35a
PE 34a or 35a
2
3221+22
3249+50
52+5153+5417
CWSPE32008
57
31a
31b3 9
33+36 or 37
2
38a 3433
38c
145
58
30 30
Fill
Best rescribe as sketched here
21+22 (repeat on the other side)
CWSPE32008
Drill hole
10
59
30
10 Film
Fill
30
CWSPE32008
Right wing tip Left wing tip
46 46
Early style gun vents
38a45 1UB
Best rescribe as sketched here
CWSPE32008
MiG-29 UB parts
21+22
21+22
32
53+54 52+51 49+50
Use parts 11 and 12 as canopy open handles
Disclaimer! The kit shown here is not mine so thePE parts are attached with sticky tape and no modifications were made to the plastic. Thank You for the understanding!
Cold War Studio2021
CWSPE32008