micro welder for mold & die repair · affordable mold and die repair solution the moldmender...
TRANSCRIPT
HOW DOES IT WORK?1. Through our proprietary non-capacitive, resistance welding process, simply place matching metallic ribbon, wire, paste or powder over the the area to be repaired.
2. Roll the electrode over this area to permanently bond the welding material to the workpiece.
3. Finish using any standard method of your choice and you once again have a new moldor die. It’s that easy.
THE SIMPLE, PORTABLE, AND AFFORDABLE MOLD AND DIE REPAIR SOLUTION
The MoldMender Micro Welder puts the power in your hands to repair parting lines, scratches, pin holes and more with ease. Whether it’s plastic injection molds, rubber processing molds, or die casting molds and dies made of steel, the fully portable and low heat MoldMender is proven to save you time and money.
WHY THE MOLDMENDER IS THE RIGHT CHOICE
Minimal heat with no distortion or splatter
Few settings and no welding experience necessary
No pre-heating or subsequent heat treating required
Low voltage, no chemicals, no welding helmet
Perfect for small scratches, dents, pin holes, errors
Self-contained, lightweight, easy to carry
Eliminate costly downtime, outside repairs, new molds
LOW HEAT
SIMPLE
QUICK
SAFE
PRECISE
PORTABLE
AFFORDABLE
ROCKLINMFG.COM
MICRO WELDER FOR MOLD & DIE REPAIR
The MoldMender Micro Welder puts the power in your hands to repair parting lines, scratches, pin holes and more with ease. Whether it’s plastic injection molds, rubber processing molds, or die casting molds and dies made of steel, the fully portable and
WHY THE MOLDMENDER IS THE RIGHT CHOICE
MADE IN USA
SPECIFICATIONSModel Number: 912Power Requirements: 110-120 volt, 50-60 Hz., A.C.(220-240 volt model available)
Dimensions: 10” x 12” x 14”
Shipping weight: 40 lbs. (18 kg)
WELDING MATERIALS AVAILABLEA-2 0-1 17-4 PHH-13 P-20 312 SSINCONEL S-7 316 SSM-2 (D-2) W-2 410 SSNICKEL STELLITE 420 SS
ROCKLINMFG.COM
110 South Jennings Street Sioux City, Iowa 51101 USA
(712) 255-6046(800) 255-6046(712) 252-5619 Fax
Giving Manufacturers an Edge Since 1934
Power Requirements: 110-120 volt, 50-60 Hz., A.C.(220-240 volt model available)
Dimensions: 10” x 12” x 14”
Shipping weight: 40 lbs. (18 kg)
WELDING MATERIALS AVAILABLEA-2 0-1 17-4 PHH-13 P-20 312 SSINCONEL S-7 316 SSM-2 (D-2) W-2 410 SSNICKEL STELLITE 420 SS
TYPICAL APPLICATIONS
Repair parting lines and edges Repair scratches and pin holes
Repair gates and vents Make design changes
Install shims Repair heat checks
Pin hole repair detail Edge repair detail