maglite sd cart 9906 - outdoorplaymaglite sd cart page 2 care rinse cart after each use to clean off...
TRANSCRIPT
Model # 22-9906
Parts List
Qty Name
1 SD Cart Frame
2 MagLite Wheel
1 Tie-Down Strap Set
Holds up to 300 LBS
MagLite SD Cart
Tools Needed : Adjustable Wrench
1. With the cart upside down, remove lock nut
from axle, fold up inner wheel guard, and
insert axle through hole in the inner wheel
guard. Attach the lock nut to axle again while
holding black knob; tighten lock nut with
wrench.
2. Undo black knob from axle. Insert axle of
wheel through hole in the outer wheel guard.
Reattach black knob onto axle and tighten
completely.
3. Repeat other side then turn cart over and
push the kickstand in place.
4. Adjust padded cradle rests to the desired
width for the hull of your watercraft
(3 different adjustments). Once adjusted,
insert locking pin through hole and hook the
loop end over the pin to secure.
Customer Service:770-518-0045
Fax: 770-518-8507
Website: www.suspenz.com
Suspenz®, Inc.
8725 Roswell Road #0-220
Atlanta GA 30350
Rev. 11/16
Customer Service:770-518-0045
Fax: 770-518-8507
Website: www.suspenz.com
Suspenz®, Inc.
8725 Roswell Road #0-220
Atlanta GA 30350
or Visit Suspenz.com
“Video & Manual” page *QR code reader app required
Scan* to see Video Instructions for Assembly & Use
Customer Service:770-518-0045
Fax: 770-518-8507
Website: www.suspenz.com
Suspenz®, Inc.
8725 Roswell Road #0-220
Atlanta GA 30350
Suspenz® products are warrantied for life against defects in material or workmanship to the original owner. Product must
be used for its intended purpose under normal conditions. Please visit www.Suspenz.com for complete warranty
information.
OUR PLEDGE TO YOU
For Technical assistance or Replacement parts: call 866.787.7369
Page 2 MagLite SD Cart
Care
Rinse cart after each use to clean off sand, salt and
mud.
Caution
This cart is designed for hand towing only.
It is not intended to be pulled behind a bicycle or
motorized vehicle.
1. Center watercraft on cart with kickstand
down for balance.
2. Secure tie-down straps by hooking the “S”
shaped hooks on each side of the frame,
then tighten and pull strap until watercraft
is secure.
3. Release kickstand and away you go!
Visit www.Suspenz.com for additional
transportation and storage solutions.
Portable Boat Stand