Application

Safety providers Fire alarming Device monitoring

Operation modes• Analog fire alarm signaling (to alarm centre)• Wireless fire alarm signal transmitting (NB IoT

(narrow-band))• Fire alarm monitoring (of the connected fire

alarm system)• Remote output control (siren)

Safety• Watchdog (monitoring and auto recovery)• Configuration settings local stored• Siren connection (input line)• Wire cut, short and sabotage detection• LED display according the alarm standards

M2M EASY 2S FIRE LTE450®

Wireless fire alarm signal transmitter and system monitoring with Narrow-Band IoT communication for dispatcher centers

Fail-safe wireless fire alarm signal transmitter for fire alarm dispatcher centers.

External fire alarm system can be connected, while the detected alarm system failures are received through the input lines. This two inputs can be used for fire alarm system monitoring and surveillance, wire cut and sabotage detection.

In case of status changes, our device is generating immediate alarms, which will be quickly transmitted – in standard Contact ID format (CID codes) – through the LTE 450 mobile network to the IP address of the dispatching center. Periodical life signals are also provided at the configured intervals.

Suitable for fire alarm signaling, system monitoring. There it can be guaranteed that wireless fire alarm signaling via mobile network is performing within the required interval (10sec).

The images on the data sheet are for illustration purposes only. WM Systems LLC. cannot be held liable for erroneous information on the data sheet. The announced data are subject to change without notice. The details on the data sheet are for general information purposes only. For more details, please contact us.

WM Systems LLC. Hungary 1222 Budapest Villa u. 8 Phone: +36 (1) 310 7075 Support: +36 (20) 333 1111 Fax: +36 (1) 319-8249

Register to our website: www.m2mserver.com Email: sales@m2mserver.com Product Support: support@m2mserver.com

Technical data

M2M Easy 2S FIRE LTE450®

Communication• LTE 450 (Cat.1) 5/10Mbps (Telit® modem)

Software features• Receiving fire alarm system signals, event

CID code generating, life signals• Wireless fire alarm signaling for dispatcher

center• Wireless fire alarm IP signaling (primary,

backup server)• Handling zones, events• Voltage/contact input line status signaling

(in case of status change)• Output switch with delay (by local, TCP)• Advanced alarm notification (reports, IO

status, alarms)• Compatible with M2M Fire protocol (SIA

CID/DTMF), Enigma protocol (Enigma II receiver, IP2 Receiver)

Configuration• EasyTerm® tool (configuration, fw refresh,

remote access)