m2000 and bsc alarm detail 1
TRANSCRIPT
There are some of the important alarms which should be kept in the mind during work in the
NOC are compiled in the table below. The reasons of alarms appearing are mentioned.
ALARM NAME SOURCE NAME REASON AND POSSIBILITIES
Cell PTP BVC Faulty BSC Gb link down
NSE FAULTY BSC Gb link down
Extern Figure Sensor1 Alarm BSC Rectifier Failure
Extern Figure Sensor3 Alarm BSC Rectifier Alarm
Extern Figure Sensor4 Alarm BSC AC Failure
Extern Figure Sensor5 Alarm BSC Door Open Alarm
MTP3 Link Unavailable BSC Either Signaling link are faulty or deactivated. Check it from BSC from MAINTAIN MTP3 LINK. May be some of A interface E1 is faulty on which it is define.
Local NM Connection Broken BSC OMCR OML link down so we are not able to perform any task in the BSC.
Loss of E1/T1 Signals ( LOS ) BSC Check whether some Ater or A interface E1 is faulty or degraded.
Main Board Out of Position BSC BSC alarm chest cable been disconnected or power of BSC alarm box gets down. Must focus on this alarm if it comes for more than 30 min than make sure to clear it on urgent basis.
LAPD OML FAULT BTS Site is down check the reason from history either transmission or Generator issue
LAPD ALARM BTS It will be on some of TRX or can be on all TRX check child alarms like SFP Port alarms.
CELL OUT OF SERVICE ALARM BTS Either the site is locked or some TRX of that sector gets down or SFP Port not consistent.
SFP PORT INCONSISTENCY ALARM
BTS the SFP Port is not inserted properly
CPRI may be damaged
Wrong configuration
ALARM NAME SOURCE NAME REASON AND POSSIBILITIES
Diversity Receive Channel Alarms
BTS Cross connected cable (diversity cables) among the DRFU get damaged or not properly inserted.
No AC input alarm BTS AC power of the BTS gets down
Cell PS Service Faulty BTS GPRS of the site or sector not working
Clock Reference Abnormal Alarm
BTS BTS is not synchronizing BSC Clock
Fan Subassembly Communication Alarm
BTS BTS Fan alarm cable is not properly inserted or FAN is not working or FAN power cable is damaged or not inserted properly.
TRX VSWR ALARM BTS This alarm is service effecting due to impedance mismatching this alarms come. Check the jumper connector, feeder connector or antenna port to remove the alarm.