logger shield - ekt2.com · logger shield introduction: logger shield will be very helpful when...

2
Logger Shield Introduction: Logger Shield will be very helpful when running out of memory space in your Arduino project. The Logger Shield adds mass - storage to your Arduino. The shield supports standard SD card and TF card, but on-board switch for you to select the socket you want to achieved over SPI interface (digital 10-13), while the CS pin is Digital Pin 10. If you use SD library of Arduino IDE, make sure to change the code to reflect the location of the CS pin. DO NOT install memory card into the socket while wired, the Logger Shield does not support hot plug. Features: Arduino compatible Standard SD card and TF card compatible Stackable Specifications: Item Min Typical Max Unit Voltage 2.7 3.3 3.6 V Current 0.159 40 200 mA Supported Card Type SD card(<=2G); Micro SD card(<=2G); SDHC card(<=16G) / Dimension 53.50x47.30x19.00 mm Net Weight 12 g you can only use one card at a time, there is a use. The communication between the Arduino and memory card is Hardware Diagram www.ekt 2 .com Electronics Katrangi Trading

Upload: duongdiep

Post on 14-May-2018

216 views

Category:

Documents


0 download

TRANSCRIPT

Page 1: Logger Shield - ekt2.com · Logger Shield Introduction: Logger Shield will be very helpful when running out of memory space in your Arduino project. The Logger Shield adds mass-

Logger Shield

Introduction:

Logger Shield will be very helpful when running out of memory space in your Arduino project. The Logger Shield adds mass -storage to your Arduino. The shield supports standard SD card and TF card, but on-board switch for you to select the socket you want to achieved over SPI interface (digital 10-13), while the CS pin is Digital Pin 10. If you use SD library of Arduino IDE, make sure to

change the code to reflect the location of the CS pin.

DO NOT install memory card into the socket while wired, the Logger Shield does not support hot plug.

Features:Arduino compatible

Standard SD card and TF card compatible

Stackable

Specifications:

Item Min Typical Max Unit

Voltage 2.7 3.3 3.6 V

Current 0.159 40 200 mA

Supported Card Type SD card(<=2G); Micro SD card(<=2G); SDHC

card(<=16G) /

Dimension 53.50x47.30x19.00 mm

Net Weight 12 g

you can only use one card at a time, there is ause. The communication between the Arduino and memory card is

Hardware Diagram

w w w . e k t 2 . c o mElectronics Katrangi Trading

Page 2: Logger Shield - ekt2.com · Logger Shield Introduction: Logger Shield will be very helpful when running out of memory space in your Arduino project. The Logger Shield adds mass-

Getting Started:

Preparation:

You have to have an SD card or micro SD card, and then format the SD card as FAT16 or FAT32 if it is SD card as the screenshots below (win7):

necessary. Format the

Reading from and writing to SD cards on the Arduino

Made in China

w w w . e k t 2 . c o mElectronics Katrangi Trading