9069171 BC-00 Revised 12/05/16

Tools Needed ∙ Safety Glasses ∙ Phillips Screwdriver ∙ Drill/Driver ∙ #2 Phillips Bit

Lock Mechanism Replacementfor Andersen® E-Series Gliding & French Gliding Patio Doors manufactured before November 2016

Use caution when working at elevated heights and around unit openings. Follow manufacturers’ instructions for ladders and/or scaffolding. Failure to do so may result in injury or death.

Follow manufacturers’ instructions for hand or power tools. Always wear safety glasses. Failure to do so may result in injury and/or product damage.

Parts Included (1) Lock Mechanism

Thank you for choosing Andersen.

For questions call 1-888-888-7020. For more information and/or guides visit www.eag lewindow.com.

Please leave this guide with building owner.

▶ Read guide from beginning to end before starting installation. Read all warnings and cautions during unit installation.

▶ Check with your local building code official to identify and confirm compliance with local building code requirements.

Lock Mechanism (Pre-April 2015) Lock Mechanism(April 2015 to November 2016)

“Andersen” and all other marks where denoted are trademarks of Andersen Corporation and its subsidiary. ©2013-2016 Andersen Corporation. All rights reserved.

Pre-April 2015 lock mechanism is shown in guide unless otherwise noted.

This guide applies to doors manufactured before November 2016. For doors manufactured after November 2016, use Instruction Guide 0005414.

29069171

Remove two (2) screws from interior handle and save for reuse.

Remove interior and exterior handles and save for reuse. Remove lock lever and save for reuse.

Unlock and open operating panel.

2Interior

3Interior

4Interior

1Interior

Interior Handle

Handle Screws

Interior Handle

ExteriorHandle

Lock Lever

Operating Panel

Remove two (2) lock mechanism screws and save for reuse.

5Interior

Drill/Driver

Lock Mechanism

Lock Mechanism Screws

Note orientation of lock mechanism before removal:

Pre-April 2015 Lock Mechanism: The original lock mechanism used on doors manufactured prior to April 2015 has been discontinued and replaced by a similar lock mechanism. Align the new lock thumb turn bushing to match the orientation of the lock being replaced.

April 2015 to November 2016 Lock Mechanism: The actuator pins should be reinstalled in the same orientation.

Lock Mechanism

Actuator Pin

6Interior

If replacing the April 2015 to November 2016 lock mechanism, the actuator pin should be reinstalled in the same orientation.

Lock Mechanism(April 2015 to November 2016)

Actuator Pin

Fasten lock mechanism using two (2) saved screws.Insert new lock mechanism with lock actuator pin or thumb turn bushing in the same orientation as determined in Step 6.

7Interior

8InteriorLock

Mechanism

Lock Mechanism

Lock Mechanism Screws

Drill/Driver

Lock Mechanism(Pre-April 2015)

If replacing the Pre-April 2015 lock mechanism, align the new lock thumb turn bushing to match the orientation of the lock being replaced.

Thumb Turn BushingUse lower bushing to match orientation.

39069171

49069171

Position lock lever into lock mechanism until fully seated. Apply interior and exterior handles.

Fasten handle using saved screws.

Close and lock operating panel. Check for correct lock operation.

▶ Lock Mechanism replacement is complete.

9Interior

11Interior

12Interior

10Interior

Interior Handle

ExteriorHandle

Lock Lever

Operating Panel For April 2015 to November 2016 lock mechanism, turn hook adjustment screw in or out for best reach and lock operation.

For Pre-April 2015 lock mechanism, turn hook adjustment screws in or out for best reach and lock operation.

Interior Handle

Handle Screws