linda r. coney – 24th april 2009 mom update linda r. coney 7 september, 2009
Post on 22-Dec-2015
246 views
TRANSCRIPT
Linda R. Coney – 24th April 2009
MOM Update
Linda R. Coney
7 September, 2009
Linda R. Coney – 7 Sept 2009
Outline
Target Taking Data/Operations Documentation Electrical Continued Run Plan …..
Linda R. Coney – 7 Sept 2009
Target Operations & Data Taking
See information by Paul Hodgson, Chris Booth, Paul Smith Many congratulations on a very well done job! Thanks to Malcolm for getting everything ready to run! Ran 12 hours Saturday & 16 hours Sunday Used 11,803 target pulses Target operation studies
Searching for ideal timing wrt ISIS cycle Searching for ideal depth into beam Found edge of beam at injection for purposes of understanding what we need to avoid on
the outswing of our target Took data with modified voltages
Beam loss vs Particle Rate study Fix target timing and adjust dip depth Take data at 100 mV, 200 mV, 300 mV, 400 mV, 500 mV beam losses
Pion beam at 333 MeV/c Proton beam at 333 MeV/c Muon beam at 252 MeV/c with Decay Solenoid and w/o
Linda R. Coney – 7 Sept 2009
Weekend Data
Run 945 Sept 06 2009 pion beam 333 MeV/c with 400mV losses
protons
Linda R. Coney – 7 Sept 2009
Weekend Data
Run947_Sept062009_piBeam333MeVc_D2up5percent
Linda R. Coney – 7 Sept 2009
Weekend Data
Run950_Sept062009_protonBeam333MeVc_D2nominal
Linda R. Coney – 7 Sept 2009
Decay Solenoid Muon Beam
Run956_Sept062009_muBeam252MeVc_DS_ON_200pulses (L) Run957_Sept062009_muBeam252MeVc_DS_OFF_200pulses (R)
Linda R. Coney – 7 Sept 2009
Preliminary:Beam Loss vs Particle Rate Study
first draft, means of distributions judged by eye, no error calcs, etc full analysis is to follow rates of beam loss seem very high because not yet been calibrated to nominals
last time the reduction factor was about 0.4, PH thinks more this time. unsure at present as to what units have for the GVA1 (why are no units for them, again to be sorted out
for full analysis)
Linda R. Coney – 7 Sept 2009
Operations
Rehearsal of running good idea Updated documentation very helpful
Still need a few updates Some trips of beamline magnets DAQ having some trouble with new fADCs
Working to sort this out now “invalid” alarms constantly going off on alarm handler extremely
taxing/annoying
Linda R. Coney – 7 Sept 2009
Other
Documentation DAQ Electrical in hall Installation of PID detectors
Would like TOF1 KL
What is our run plan for Machine Physics given all that was done this weekend??