lc6 loop control user guide
TRANSCRIPT
2
1 Introduction
In order to Hunkeler Loop Control Module running the day-to-day maintenance, is be covered by
you, a trained operator. Only in case of malfunction or in case of scheduled service-maintenance, the
local service organization is involved.
The actions below are considered to be normal maintenance actions which can be executed by every
trained operator.
In order to increase the uptime of the system, it is possible to give an additional training, which
enables you to conduct a number of maintenance actions which are normally executed by the
service engineer. In addition you can do some checks and execute ‘normal’ maintenance actions
preventive which might prevent future problems and/or increase the uptime.
This document describes the so called ‘advanced Key Operator Maintenance’. It can be used by you
as reference and logbook.
In order to perform the Level 1 Uptime Optimization actions, you need to have some additional
tools:
A flashlight
Straight slot Screwdriver
Phillips Screwdriver
Vacuum cleaner
It is up to the local organization to arrange these. Also the normal maintenance tools and supplies
are needed:
Isopropyl Alcohol
Water
Nitrile gloves
Cleaning cloth
Cleaner
Antistatic cleaner
Lubricating Oil (Provided by Field Engineer)In this document, a couple of times we askyou to ‘inform service’ in case you notice something during a check. Note that yousupposed to inform the service engineer via the logbook at the rear of this document.Only submit a service call in case the system is not working accordingExpectation/specification.
In case you encounter problems during performing maintenance actions, please add
this in the ‘remark’ section at the rear of this guide. An engineer will have a look at it
as soon as he is on site.
3
2 Table of Contents
1 Introduction 2
2 Table of Contents 3
3 Daily Maintenance 4
3.1 Clean the Module 4
3.2 Clean the optical sensors 5
3.3 Clean the antistatic rod 6
4 Weekly Maintenance 7
4.1 Clean the pressure roller 7
4.2 Clean the deflection rollers 8
5 Logbook 9
6 Operator Notes 10
9
5 Logbook.
O = Checked and no action needed.
X = Checked and executed action.
3 Daily Maintenance
3.1 Clean the Module
3.2 Clean the optical sensors
3.3 Clean the antistatic rod
4 Weekly Maintenance
4.1 Clean the pressure roller
4.5 Clean the deflection pulleys
3 Daily Maintenance
3.1 Clean the Module
3.2 Clean the optical sensors
3.3 Clean the antistatic rod
4 Weekly Maintenance
4.1 Clean the pressure roller
4.5 Clean the deflection pulleys
Date:
Date:
Operator:
Operator:
10
3 Daily Maintenance
3.1 Clean the Module
3.2 Clean the optical sensors
3.3 Clean the antistatic rod
4 Weekly Maintenance
4.1 Clean the pressure roller
4.5 Clean the deflection pulleys
3 Daily Maintenance
3.1 Clean the Module
3.2 Clean the optical sensors
3.3 Clean the antistatic rod
4 Weekly Maintenance
4.1 Clean the pressure roller
4.5 Clean the deflection pulleys
Operator:
Operator:
Date:
Date: