How to Lay Floor TilesTiles are the ideal flooring choice for kitchens, bathrooms, utility rooms, and high traffic areas. Whether it is for a new building or a renovation.

www.topline.ie

How to GuidesTopline - Home, Garden & DIY

Step 1: Prepare Surrounding Area

• Remove all fittings and fixtures that are attached to the floor, such as the toilet, sink and cupboards. Pull up any existing floor covering such as linoleum or carpet; floor tiles need a solid base in order to prevent the grout from cracking.

• Never lay tiles directly onto floor boards; screw down a sheet of half inch plywood first using corrosion resistant screws.

Step 2: Plan Layout

• It is important to plan your tiling properly. It is unlikely that the floor will be exactly the right width and length that you will not have to cut any tiles, so planning will help you decide where cut tiles will be needed and to what size they need to be cut.

• Lay a cross shape of full sized, uncut tiles from one end of the room to the other. You will want the cut tiles to have as little visual impact as possible so consider the positioning of the bath, toilet and cupboards.

Step 3: Prepare Tile Spacers

• Tile spacers are used to help you space tiles out evenly, creating a professional finished look.

• It will be necessary to trim the tile spacers for use around the edge of the room.

• Carefully use a sharp knife to remove one or more of the arms as required.

Step 4: Apply Tile Adhesive

• Apply tile adhesive directly to the floor with a toothed floor tile applicator.

• Apply adhesive to a small section at a time.

Step 5: Lay First Tile

• Position the first tile into place and press down firmly on the tile with the heel of your hands. This is important to ensure the tiles will be completely flat and not sitting proud on a layer of adhesive.

• While tiling, avoid putting your body weight on to the newly laid tiles; give tiles 24 hours to fully set first. Always work backward towards the door.

Step 6: Lay Rest of Tiles

• Position the next tile beside the first tile using the tile spacers to keep the joints uniform. Check the alignment of the tiles as you go along with a spirt level to ensure the tiles are both level and straight.

• Repeat steps 4 – 6 until the whole floor is tiled.

www.topline.ie

Topline - Home, Garden & DIY

Read the full guide here: www.topline.ie/how-to-guides/how-to-lay-floor-tiles

©Topline 2015. All rights reserved.