kyoto collection...these assembly fittings for the kyoto collection instructions apply to the...
TRANSCRIPT
KYOTO COLLECTION
ASSEMBLY INSTRUCTIONS
FITTINGS FOR THE KYOTO COLLECTIONTHESE ASSEMBLY INSTRUCTIONS APPLY TO THE FOLLOWING MODELS:
• Kyoto Bed, Kyoto Bed with Headboard
• Kumo Bed, Kumo Bed with Headboard
• Kobe Bed, Kobe Bed with Headboard
3 X NUTS*
3 X DOME HEAD BOLT*
4 X WASHERS
1 X ALLEN KEY
3 X HALF
MOONWASHER*
1 X SPANNER
4 X SCREWS
6 X FLAT HEAD
BOLT
1.Place the rails on the legs as
shown, then screw in the flat head bolts with the allen key.
* 2 IF SINGLE BED
(only additional tool required is a Philips head screwdriver):
* Please note - All timber sections have numbers pressed into the timber where they are tied together to indicate how they should be positioned (e.g side
rail hole1 connects to leg rail hole1).
* Please note - Single bed bases will not include a centre rail
2.Using the dome headed
bolts connect the headboard panel to the side/centre rails
- secure with the half moon washers and nuts. Tighten
with the spanner.
3.
Position the head end panel and foot end panel - secure using the small
washers and screws provided.* If you have ordered a bed without a headboard please
ignore this step.
4.
* Please note - if you have ordered a standard single (90cm) or super-king (180cm) bed base you will also
receive a set of double slats with sliders. These slats are for holes 4-9 from the head of the bed base.
Place the end caps on the sprung slats and attach
(centre of the gently curved slats should be upwards)
THANK YOU FOR BUYING A BED FROM
DEVONSHIRE POINT, 123-125 FITZWILLIAM STREET, SHEFFIELD, S1 4JP T: 0114 272 1984
E: [email protected] W: WWW.NATURALBEDCOMPANY.CO.UK