korrektur · 2019. 8. 7. · antriebstechnik \ antriebsautomatisierung*24768138_0819* \...
TRANSCRIPT
*24768138_0819*Antriebstechnik \ Antriebsautomatisierung \ Systemintegration \ Services
Korrektur
SNI-I/O-System
Ausgabe 08/2019 24768138/DE
SEW-EURODRIVE—Driving the world
Inhaltsverzeichnis
Korrektur – SNI-I/O-System 3
Inhaltsverzeichnis1 Korrektur ................................................................................................................................... 4
2 Elektrische Installation ............................................................................................................ 52.1 Installationsvorschriften .................................................................................................. 5
2476
8138
/DE
– 08
/201
9
1 Korrektur
Korrektur – SNI-I/O-System4
1 Korrektur
HINWEISIn der Betriebsanleitung "SNI-I/O-System" haben sich Änderungen ergeben, die indiesem Zusatz beschrieben sind:Dieses Dokument ersetzt nicht die ausführliche Betriebsanleitung!• Neues Kapitel "Elektrische Installation/Installationsvorschriften/UL-compliant in-
stallation".
2476
8138
/DE
– 08
/201
9
2Elektrische InstallationInstallationsvorschriften
Korrektur – SNI-I/O-System 5
2 Elektrische Installation2.1 Installationsvorschriften2.1.1 UL-compliant installation
HINWEISDas folgende Kapitel wird unabhängig von der Sprache der Ihnen vorliegendenDruckschrift aufgrund von UL-Anforderungen immer in englischer Sprache abge-druckt.
Power terminalsObserve the following notes for UL-compliant installation:• Use 60/75 °C copper wire only.• Line terminal X2: Tighten terminals to 10.6 - 12.4 in-lbs.• PE connection: Tighten terminal to 18 - 21 in-lbs.
Short circuit current ratingWhen installed in combination with Listed MOVIGEAR® MG Drives and/or ListedDRC.. Drives, MOVIFIT® and MOVIPRO®.Suitable for use on a circuit capable of delivering not more than 200,000 rms symme-trical amperes when protected by 600 V non-semiconductor fuses or 500 V minimuminverse time circuit breakers.• The max. voltage is limited to 500 V.
Branch circuit protectionIntegral solid state short circuit protection does not provide branch circuit protection.Branch circuit protection must be provided in accordance with the National ElectricalCode and any additional local codes.The table below list the permitted maximum branch circuit protection:
Series Non-semiconductor fuses
Inverse time circuit breakers
SNI-I/O System 40 A/600 V 500 V minimum/40 A maximum
2476
8138
/DE
– 08
/201
9
SEW-EURODRIVE—Driving the world
SEW-EURODRIVE GmbH & Co KGErnst-Blickle-Str. 4276646 BRUCHSALGERMANYTel. +49 7251 75-0Fax +49 7251 [email protected]