- Moves Left - Moves Right - Selects Mode - Cancels Mode WARNING: Use this CARD as Reference only (Training aid)! Read the Operations Manual before operating! EMMS: Equipment Management Monitoring System SEPB201301 Service Technology Development Group Customer Support Division > < Normal Monitor Display Key "ON" Ignition key must switched to the "ON" position and the machine must be in the "PARK" mode in order to allow access to the functions on the monitor display. When using the “Select Mode” to access menu, the switch must be held in the <> position at least 3 to 4 seconds in order to access menu functions in the Operator Mode. - Maintenance Mode Functions - > < > < Scroll through the menu Scroll through the menu or or > < YES or YES or NO NO enter enter < The maintenance interval is re-set and the monitor display returns to the maintenance item chosen. YES YES enter enter No action is taken. NO NO > enter enter The maintenance item is not re-set and the monitor display returns to the maintenance item chosen. NO NO > select select - PM Clinic Functions - > < > Scroll through the menu Scroll through the menu or or < After selecting the system to be monitored from the menu shown above, you can take a snap-shot of a time frame within that system. By using the select mode function you can capture and hold a time frame within a systems. An “H” will appear on the left of the screen and all monitored movement will hold until canceled. Select and hold “H” Cancel hold Exit function An Action Code will automatically be displayed when a serious fault occurs in the system. There are 4 Action Codes . E01 -Only action code is displayed No. Maintenance item 1 01:ENG OIL Engine oil 2 02:ENG FILT Engine oil filter 3 03:FUEL FILT Fuel filter 4 04:HYD FILT Hydraulic oil filter 5 05:CORR RES Corrosion resistor 6 06:BYPS FILT Bypass filter 7 07:DAMP OIL Damper oil 8 08:FNL OIL Final drive oil 9 09:HYD OIL Hydraulic oil 10 10:POWL Oil Power train oil 11 11:POWL FILT Power train oil filter 12 12:HST FILT HST charge filter (HST spec) No. Pm clinic auxiliary item Unit 1 01-ENG. SPEED Engine speed rpm 2 02-BATTERY VOLT Battery voltage mV 3 03-HST TEMP ? C 4 04-VEHICLE SPEED ? km/h E01 -Only action code is displayed E02 -Only action code is displayed E03 –CALL+ action code is displayed E04 –CALL+ action code is displayed
