joint fuel monitoring management system
TRANSCRIPT
-
8/6/2019 Joint Fuel Monitoring Management System
1/11
- 1 -
Jointech Fuel Level ConsumptionMonitoring Management System
Content
I total solution introduction .....................................................................................................................................................- 1 -
II. How does Jointechs fuel monitoring solution differ from others? ........................................................................- 3 -
III. The powerful tracking software with fuel consumption reports ...........................................................................- 4 -
IV. The advanced technology of Jointechs high resolution and sawed-off sensor ...............................................- 9 -
I total solution introduction
Monitoring multi fuel level of tank
The high resolution capacitive fuel sensor
The fuel sensor could be sawed into any length you want on spot;
Real time fuel monitoring and fuel analyzing report accurately
-
8/6/2019 Joint Fuel Monitoring Management System
2/11
- 2 -
Jointech offer:Smart tracker : GP6000
Monitor up to 9 fuel signal,
Configure alarms parameter for each fuel tank.
Capacitive theory sensor
High accurate 0.5%, resolution 1 mm
Be sawed off
-
8/6/2019 Joint Fuel Monitoring Management System
3/11
- 3 -
I I . How does Jointechs fuel monitoring solution differ from
others?
Do you have the follow ing trouble?
1. Poor resolution for the fuel sensor with float; and sometimes the float stop to workbecause of adhesion;
2. The fuel sensor could not be sawed on spot;
3. Two fuel tank monitoring could not be done correctly;
4. Diesel stolen; hard to take the evidence of giving fake charging invoice
5. Poor accuracy of the report for the driver working status
6. Poor analyzing report
7. Poor ROI analyzing.
you can find out w hen you use JOIN TECHS fuel monitoring solution:
Where, when, how many litres your diesel has been stolen?
Where, how many diesels you have consume?
Where the vehicle is in idling state?
How many litres you have wasted in idling?
-
8/6/2019 Joint Fuel Monitoring Management System
4/11
- 4 -
Wh ether you fill 586.63USD fuel into your tank really?
II I. The powerful tracking software w ith fuel consumption
reports
Management methods in fuel level consumption solution:1. Real time fuel consumption and abnormal fuel level change alarms
-
8/6/2019 Joint Fuel Monitoring Management System
5/11
- 5 -
There are 3 parts in the fuel real time monitoring interface.
The fuel abnormal consumption alarms could be send viasoftware, SMS, Email real time sending.
You could also trigger the camera to take photos of the fueltank. When the fuel alarm was creating .
2. Fuel charging and fuel abnormal consumption checking:
-
8/6/2019 Joint Fuel Monitoring Management System
6/11
- 6 -
Comprehensive analyzing the speed, fuel consumption, mileage, engine status and otherstatus of vehicle ;If the mileage is not adding, no speed, fuel decrease slowly, engine on, then we judge it asidling status;If the mileage is not increasing, no speed, fuel level decrease quickly, engine off, we judgeit as : FUEL stolen.If the mileage is not increasing, no speed, fuel level increase quickly, engine off, we judge
it : Fuel charging.
3. Fuel chart analyse report
-
8/6/2019 Joint Fuel Monitoring Management System
7/11
- 7 -
In order to have an accurate report, jointech fuel level monitor software optimize theparameter:
4 Fuel analyse general report
Fuel analyzing sub-report
-
8/6/2019 Joint Fuel Monitoring Management System
8/11
- 8 -
-
8/6/2019 Joint Fuel Monitoring Management System
9/11
- 9 -
I V. The advanced technology of Jointechs high resolution and
saw ed-off sensor
1. Comparison list with normal float sensor
Type Jointech capacitive fuel sensor Reed Switch fuel sensor
Picture
Workingprinciple
capacitance
The sensor part is a coaxescontainer, capacity betweenthe sensor body and induction
electorde would be changedwhen the oil gets into thecontainer,which can betransformed by the circuit,then get the required signalby precise compensation of linear and temperature.
Distributed resistance
There is magnetic inside thereedswitch, which can made switchinside the sensor close/open, it
leads to the change of resistance,the required signal would beavailable after circuittransformation.
Accuracy 0.5% 2%
-
8/6/2019 Joint Fuel Monitoring Management System
10/11
- 10 -
Resolution 1mm 12mm/21mm
Workingcurrent
-
8/6/2019 Joint Fuel Monitoring Management System
11/11
- 11 -