iServ Technical Firmware ManualHandset: 8630

Base: 8660Repeater: 4024

RequirementsHandset:• USB Dongle.• Firmware. (Mia Tech)• Root Directory Files:

– FL7.– Set Provider.– FwuPath.

• Raffle.Base Station:• DHCP (Any Switch providing DHCP will work).• Handset – To get the Base IP.• Google Chrome – Not Internet Explorer, as it Cache’ the sites.• Pumpkin (Any TFTP Program).• Firmware (Mia Tech)• Root directory Files:

– FwuPath• Beatus

Repeater:• USB Dongle – Repeater Dongle.• USB Drivers (Same as for the Handset).• Firmware• Root Directory Files:

– Repeater Upgrade– FwuPath

• DECT4024

Firmware Locations

• Samsung Dealer:• http://www.miatech.co.za/Partner/Technical/Soft

ware/I-Serv%20IP%20DECT/• Username: “Dealer Username”• Password: “Dealer Password”

• NON Samsung Dealer:• http://www.miatech.co.za/Partner/iserv/• Username: iserv• Password: iserv

Handset Procedure• Place the “FL7” file in root directory.• Install the USB Driver.• Insert the Dongle.• Check Comport in Device Manger.

• Go to the root file:• Open FL7.cfg with Notepad.• Edit the Comport.• Save & Exit.

Insert the Dongle into the earphone jack of the handset. Handset must be off.• Open CMD Prompt and type the following:

• Cd\• Cd FL7

Do Not press Enter until the button config has been done.• Fl.bat pega (Press the TAB button, this will auto complete the file name).

C:\FL7>fl.bat PegasusMKII_Raffle_Pp_and_boot_v0179_b0004.hexOnce the above line is in the CMD, do the following sequence:

• HOLD DOWN the Dongle button.• HOLD in the RED button on handset.• LEAVE the Dongle button.• Press ENTER on the CMD prompt.ONLY Leave the Red button once the numbers has started counting.

• Once it has completed, remove and replace battery.FIRMWARE IS COMPLETE.

Base Procedure• Place the “FwuPath” file in root directory.• Install Pumpkin.

– Go to Options:• Download Path: C:\• Give all files.• Take all files.

Open Management Tab on Base station: Menu*47*– Management transfer Protocol: TFTP– SysLog Level: Debug

• Open Firmware Update Tab:– Firmware Update Server Address: PC IP Address– Firmware Path: \FwuPath– Click Save.– Update Base Stations:

• Update this Base Station Only– Stand Alone

• Update All Base Stations– Multi Cell Setup

– Insert the required version and click save.• Pumpkin will start sending the files.• Base will flash Rapid red then have solid green.FIRMWARE COMPLETE.

Repeater Procedure• Place the “Repeater Upgrade” file in root directory.• Install the dongle drivers.• Check Comport in Device Manager.

• Go to Root file: Open FL7.cfg with Notepad.• Edit the Comport.• Save & Exit.

• Open CMD prompt and type the following:• Fl.bat rota (Press the TAB button, this will auto complete the file

name).C:\Repeater Upgrade>fl.bat Rota.spi_v0026.hex

• Insert the Dongle into the Dongle kit and Repeater.• Press and HOLD the Dongle Button.• Insert the Power cable into the Dongle Kit.• Release the Dongle button.• Press enter on the CMD Prompt.Wait for Success.FIRMWARE COMPLETE.

Repeater Upgrade Kit