IP-700 Specification• Video input

Supporting NTSC/PAL system• Video compression

H.264 baseline profile@ Level 2.2• Video resolution

PAL: 320*240 (QVGA), 640*480 (VGA)NTSC: 320*240 (QVGA), 640*480 (VGA)

• Video parameter adjustmentBrightness, chrominance, contrast, saturation, and image quality

• CMOS parameter adjustmentAutomatic White Balance (AWB), Automatic Gain Control (AGC), Backlight Compensation (BLC), Automatic Light Control /Electronic Light Control (ALC/ELC)

• Stream formatPure video stream or composite video & audio stream

• Video frame ratePAL: 1 – 25 frame/second; NTSC: 1 – 30 frame/second;

• Video compression code rate16Kbit/S ~ 8Mbit/S

• Audio inputOne linear input, impedance: 2.2KΩ

• Audio compressionG.726

• Audio outputOne linear output

• Call inputOne microphone input, built-in/external optional, red for built-in and white for external

• Communication interfaceOne 10M/100M adaptive Ethernet interface

• Input powerDC 12V 1A

• Maximum powerLess than 5W

• Operating temperature-10 ~ +55ºC

• Operating humidity10 ~ 85%

• Storage temperature-20~+70 ºC

• System requirementOperating system: Microsoft Windows 98/2000/ME/NT 5.0/XP/VistaBrower: Microsoft Internet Explorer 6.0 or later version

• Wi-Fi moduleInfrastructure mode

• Dimensions (W´D´H)104 ´ 125 ´ 106mm

• Weight (approx.)252g

IP-700 Setup Instructions

Step 1

• Plug one end of the Ethernet cable into the Ethernet port on the back of your camera, and the other end into your router.

• Then plug the power adaptor into a power socket, and the cable to the power slot on the back of your camera.

• Once you insert the power cable, the Power indicator light should turn green, and after a few seconds, the camera will also automatically start to pan and tilt; this is normal.

Step 2

• Please check the Network Indicator on the front of the camera to make sure that the light is green; this indicates that the camera is connected to the Internet. If there is no green light, then recheck your router to make sure that it is working and also check that the Ethernet cable is securely plugged into the camera and router.

Step 3

• Next, go to http://astak.yoics.com

Step 4

• Click on the “Signup” button. A form will appear - please fill it out and then click on the “Register” button.

Step 5

• Then you will find the following page:

• Click on the “Complete Registration” link.

Step 6

• Then on the “register new devices” page, type in a name for your camera in the “Yoics Device Name” box. (For example, “Amy’s camera” is shown in the picture below.) Then click the “Register Now” button.

Step 7

• In a few minutes, you should receive a registration confirmation email from Yoics at the email address you entered in the form. You will also be redirected to this webpage, shown below. Under the My Stuff , click on the

name you gave your camera.

Step 8

• You will see a pop-up window

• Type in “admin” as the default Username, and “admin” as the default Password. You are free to change the username and password later if you wish. Then click on OK.

Step 9

• Congrats! Now you have finished the registration process. You are now on the camera’s browsing interface, and you should be able to see input from the camera on your computer screen. Note: if you want to login to this browsing interface from another computer, just go to http://astak.yoics.com and enter your username and password.