A Presentation on

Raspberry-piByPraveen DewanganED-500 NIELIT,Calicut

A Small Introduction

-credit card size single board ,super low cost computer..

-Developed in UK by Raspberry-pi foundation in 2009.

-to promote the study of basic computer science in schools.

-element 14,RS components and Egoman tech corp,these are the distributors of the product all over the world.

A Small Introduction

Credit card size single board ,super low cost computer..

Developed in UK by Raspberry-pi foundation in 2009. supported by “University of Cambridge Computer laboratory & Broadcom”

To promote the study of basic computer science in schools & to develop interest among kids and adults.

The Foundation has produced two models

$25 $35

INR 1625 INR 2275

S o C

Broadcom BCM2835“High Definition Embedded Multimedia

Application Processor.”

Uses ARM1176JZF-S(ARM v6)J- Jazelle bytecodeZ- Trust zoneF- Floating pointS-Synthesizable core.

AMBA-3 improves memory bus performance.

Power Supply

Micro USB power supply5v,700mA=3.5Wwhich is less than a bulb.Standard Charging port.Universal charging solution by

GSMA.

USB Keyboard & Mouse

Monitor

Supports only HDMI.Old analogous TV, Modern

digital TV Destop Monitor or even your smartphone as a display.

SD memory card Min 2GB,expandable upto

32GB

-Home Automation System.

OS-mainly linux based OS.-OS and Programming language

Supports only Linux.Fedora , Archlinux & Desbian .Most recommended Desbian ,Because it supports python programming language.

Raspberry Pi Versions of Kernels are available

Fedora-PidoraDesbian-Raspbian

How it differs from other Board

Low power consumption

PC takes 65-250WLaptop takes 15-60W

Low costSmall in size

ApplicationsHome Automation System.

Home Security System.

HD surveillance  Camera.

Media Center.

We can develop what we can think using GPIO.

these are the licensed distributors of the product all over the world.

Distributers Of Raspberry pi

Handling the RP

-The Raspberry Pi was built to be used, but not abused. EveryPrinted Circuit Board (PCB) should be handled with care.

-Handle the RP only by the edges of the board itself.Avoid touching or holding any of the components on theboard.

-Rough handling can cause solder points to fail and may result in short circuits, but be careful with the GPIO pins as well.

Thank

you!!