installing vmware & the data ontap simulator se technical academy
TRANSCRIPT
Installing VMware & the Data ONTAP Simulator
SE Technical Academy
Installation Overview
Copy the trial version of vmware™– When you return to your office you should request
approval from your manager for a fully licensed version. You will be able to just plug in the serial number once you receive it. You will not have to reinstall.
– http://se-web.corp.netapp.com/cgi-bin/form_engine/form_engine.pl/se_tools/iwant/index.html?conf=vm_license
Install vmware
Copy the Linux Image
Setup the simulator
Create a Directory on your machine
Create a directory somewhere on you machine called SETA
Copy all the files from the CD (provided by your instructor) to this new folder.
Double-click VMware-workstation-5
Double-click the VMware-workstation-5.Temp.exe to begin the VMware installation.
Accept all the defaults for the installationEnter the Serial #, Click Finish
Accept all the defaults for the VMware installation.
When prompted open VMWare_Temp_License.doc for the temporary Serial Number.
Double-click the RH_Linux9.exe file. Browse to My Virtual MachinesUnzip
Double-click RH_Linux9 folderDouble-click RedHat_Linux9.vmx
Add this VM to your favoritesVM | Add to Favorites
Set the CD-ROM iso fileFollow the 7 steps, then click OK
1
2
3
4
5
6
7
Start the virtual machine
1
If you get either of these messages,Click OK
Start the virtual machineKeep the existing identifier
2
It may take a minute to look like this.Enter your login and password
Login: root
Password: netapp
Login: root
Password: netapp
Note: Use Ctrl-Alt to move in and out of the simulator window.
Note: Use Ctrl-Alt to move in and out of the simulator window.
Issue the following commands to mount the CD drive & begin simulator installation
Accept defaults except where noted.
Accept defaults except where noted.
Continue Simulator InstallAdd 11 disks
Accept defaults except where noted.
Accept defaults except where noted.
As much as you have room for, in this case 11 Gigabytes
Simulator Installation Complete
Starting the Simulatorcd /sim./runsim.sh
Hostname[]: Enter Something Heretimezone [GMT]: US/Pacific New password: netapp
netappnetapp
Accept defaults except where noted.
Accept defaults except where noted.
Note: Hostname will show up as your CLI prompt “filer70>” in this case.
Defaults, netapp and 2 for Workgroup authentication.
netappnetapp
Accept defaults except where noted.
Accept defaults except where noted.
Defaults and set another password
netappnetapp
Accept defaults except where noted.
Accept defaults except where noted.
Congratulations! You have a filer, a simulated filer that is.
netapp
Accept defaults except where noted.
Accept defaults except where noted.
Press the Enter key.
ifconfig –a To get your IP address for you filer
http://ipaddress of filer/na_adminLaunches FilerView for your simulator
User: root
Password: netapp
User: root
Password: netapp