installation manual mobile tv stand trolley with shelf · installation manual 8. adjustment...
TRANSCRIPT
Mobile TV Stand Trolley with Shelf
CAUTION: DO NOT EXCEEDRATED LISTED WEIGHT. SERIOUS INJURY OR PROPERTY DAMAGEMAY OCCUR!
INSTALLATION MANUAL
8. Adjustment
Maintenance• Check that the bracket is secure and safe to use at regular intervals (at least every three months). • Please contact your distributor if you have any questions.
Adjust the display to the desired location then tighten the knobs.
7. Hanging the Display onto the Universal Plate
TV Stand
200x200300x300400x200400x400600x400
PS-MTSTWS28B 70"MAX
50kg(110lbs)
RATED
50kg(110lbs)
RATED
TVTV DVDDVD
10kg(22lbs)RATED
10kg(22lbs)RATED
Tighten the two screws by using a proper screwdriver to secure the adapter brackets to the universal plate.
+10°
-10°
CAMERACAMERA
5kg(11lbs)RATED
5kg(11lbs)RATED
WARNING
21
Package M
NOTE: Read the entire instruction manual before you start installation and assembly.
Package
• Do not begin the installation until you have read and understood all the instructions
and warnings contained in this installation sheet. If you have any questions
regarding any of the instructions or warnings, please contact your local distributor.
• This mounting bracket was designed to be installed and utilised ONLY as
specified in this manual. Improper installation of this product may cause damage
or serious injury.
• Always use an assistant or mechanical lifting equipment to safely lift and position
the equipment.
• Tighten screws firmly, but do not over tighten. Over tightening can cause damage
to the items, This greatly reduces their holding power.
• This product is intended for indoor use only. Using this product outdoors could
lead to product failure and personal injury.
column 2H
(x ) universal plate (x1)I
left shelfsupport (x1)
K
right shelfsupport (x1)
L
DVD/AV components shelf 1J
(x ) camera shelf M
(x1)
D6 washer (x8)
P-Gwrench
P-J
8mm Allen key (x1)
P-L
5mm Allen key (x1)
P-KM8
P-H(x12) M6
-I(x4)
P
M6x10 -A
(x4)P
M5x8 -B
(x2)P
M8x65 -C
(x12)P
M10x35 -D
(x2)P
D10 washer (x2)
P-E
D8 washer (x4)
P-F
connecting plate N
(x1) right adapter bracket O
(x1) left adapter bracket P
(x1) plastic stopper Q
(x2)
Component Checklist
IMPORTANT: Ensure you have received all parts against the component checklist prior to installation. If any parts are missing or faulty, contact your destributor for a replacement.
base 1C
(x )
plastic cover D
(x2) caster with brake G
(x2)caster F
(x2)washer 4E
(x )
short support leg 2A
(x ) long support leg B
(x2)
washer M-F
(x4) big spacer M-H
(x8)small spacer M-G
(x8)
M6x30 M-C
(x4)M6x14 M-B
(x4) M8x30 M-D
(x4)M5x14 M-A
(x4)
M8x50 M-E
(x4)
43
2.Installing the columns1.Installing the Base Assembly
Insert the casters into the holes and tighten the castersto secure. Note: Make sure all casters are at the same height.Note: Lock the brakes on the casters to avoid any sudden movements during installation.
Attach the universal plate to the columns using the appropriate screws,washers and nuts.
3.Installing the Universal Plate
F
G
AB
C
D
-C x8P
E
-H x8P P-J
H
I
P-K
P-C x4
P-F x4
-H x4P
P-D x2
P-E x2
P-L
G
F
Attach the support legs to the base using the appropriate screws, washers and nuts.
P-K
Snap the plastic covers onto the base.
Attach the columns to the base using the appropriatescrews and washers, then tighten all screws with theAllen key.
Tighten all screws but do not over tighten.
Tighten all screws but do not over tighten.
Tighten all screws but do not over tighten.
Note: Each caster can be adjusted independentlyfor fine tuning. Slightly turn the nut to lower orraise the base.
P-J
5
4. Installing the Camera Shelf
5. Installing the DVD/AV Components Shelf
· Attach the shelf supports onto the DVD/AV components shelf.
· Hook the DVD/AV components shelf onto the columns assembly.
· Attach the camera shelf to the connecting plate using the screws.
· Attach the assembled camera shelf to the universal plate using the appropriate screws, washers and nuts.
P-G x8
-KP
M
N
P-B x2
-KP
P-A x4
-I x4P
Tighten all screws but do not over tighten.
J
K
L
Q
Attach the plastic stoppersto the DVD/AV componentsshelf to prevent the shelffrom falling off unexpectedly.
6. Installing the Adapter Brackets
Tighten all screws but do not over tighten.
· Position the adapter brackets as close as possible to the center of the displays.· Screw the adapter brackets onto the displays.
6a. For Flat Back Screens
6b. For Bump-out or Recessed Back Screens
TV
TVTV
TV
TVTV
Note: Choose the appropriate screws, washers and spacers (if necessary) according to the type of screens.
P O
M-F
M-AM-B
M-F
M-CM-D
M-G
or
M-F
M-CM-D
M-H
M-F
M-CM-D
M-G
or
M-H
M-F
M-E
or
M-H
M-F
M-E
or
M-H
M-G
M-F
M-E
M-H
M-G
6