Camaro engine

Tensioner

•

A/C Bracket for truck or 5th gen Camaro LS engines

•Idler pulley

Installation Instructions for K10472

Additional parts required:

•

Kit contents:

less vibration.

Mounting plates•Spacer tubes•Fasteners

- Belt. See chart below.- AC compressor, Sanden "508" style. Typical SD5 Sandenpart number is 6629. However, we recommend the SD7Sanden part number 4665 for smoother operation and

www.kwikperf.com

IndicatorReferencemarks

Proper tensioner positionwith belt installed:

groove compressor.

Belt installationNote:Install belt in rear 6grooves of the 7Truck engine

16.30

15.22

12.07

13.86

6.7" diameterpower steering

pulley

6.0" diameterpower steering

pulley

5.5" diameterpower steering

pulley112.88" K061123 102.6" K061020 98.13" K060975 97.13" K060966 96.88" K060962 91.25" K060909

Factory GM 2010+Camaro Alt/PS

bracket and pulley

Kwik Performance Alt/PS bracket K10168Kwik Performance

alternator onlybracket K10195

Factory GM truckAlt/PS bracket and

pulley

Belt length and Gates PN - K10472 AC bracket - Truck (130+ amp alternator) and 2010+ Camaro spacing

12.00304.80

279.4011.00

M10x75mm bolt

tensioner &4. Install

idler pulley

M12x55 bolt

SpacerNote: Only install if thebelt runs off the rear ofthe tensioner pulleyafter installing the belt.

A

Bolt screws into water pump

M10x40mm on 2010+ CamaroM10x80mm on truck engine

1" OD tubes:2-1/4" long for truck engine23/32" long for 2010+ Camaro

2. Install WaterPump Bolt

50 ft-lbs (68 N-m).Tighten 12mm fasteners to

3. Installcompressor

1. Installbracket

All rights reserved

to 37 ft-lbs (50 N-m),

Copyright 2018-2019

5. Tighten bolts.

Kwik Performance, Inc.

Tighten 10mm fasteners

Installation Instructions for K10472A/C Bracket for LS engineswith truck or 2010+ Camaro balancer

Front plate

Do not torque until

screw into headuntil finger tight.

after step 4.TUBES

Rear plate M10x150mm bolts

1" OD x 1-9/16

1" OD x 3" TUBES

M10x55mm

M10x35mm

3/4OD x 3/4 LG tube

F