Install Trimble Access Using a TSC2

California Surveying & Drafting Supply Technical Support Services

© Copyright 2000-2010 California Surveying & Drafting Supply. Not to be copied or distributed without permission. 1

1. Download Trimble Access Installation Manager from the Trimble website. Click this link, or type this address into your web browser:

http://taim.trimbleaccess.com/TrimbleAccessInstallationManager.msi

2. When you see the Security Warning, click “Save”.

3. Select “Desktop”, then “Save”.

© Copyright 2000-2010 California Surveying & Drafting Supply. Not to be copied or distributed without permission. 2

4. When the download is complete click “Run”.

5. Then Click “Run” again to start the installation wizard.

© Copyright 2000-2010 California Surveying & Drafting Supply. Not to be copied or distributed without permission. 3

6. At the first screen click “Next”

7. Read the License Agreement, if you agree click the “I Agree” dot and click “Next”

© Copyright 2000-2010 California Surveying & Drafting Supply. Not to be copied or distributed without permission. 4

8. Here you can specify the folder Trimble Access Installation Manager will be installed in, if this is ok click “Next”

9. Then click “Next” again.

© Copyright 2000-2010 California Surveying & Drafting Supply. Not to be copied or distributed without permission. 5

10. Make sure the “Launch Trimble Access Installation Manager” is checked and click “Close”. The Trimble Access Installation Manager will start automatically.

© Copyright 2000-2010 California Surveying & Drafting Supply. Not to be copied or distributed without permission. 6

11. If TSC2 is not connected connect it now via USB, then click “Start”.

NOTE: Trimble highly recommends connecting your power supply to your TSC2 to avoid power loss during install, which may corrupt the system.

© Copyright 2000-2010 California Surveying & Drafting Supply. Not to be copied or distributed without permission. 7

12. Click “Finish”

when complete.

13. On the TSC2 read the license agreement and click “I agree”. If you do not want to see this message again uncheck the “Show on startup” box.