ideal for remote sites - campbell sci · ideal for remote sites low power use; wide operating...
TRANSCRIPT
COMPONENTS
COM220Phone Modem
www.campbellsci.com/com220
Ideal for Remote Sites
Low power use; wide operating temperature range
More info: 435.227.9120
A COM220 is connected with a CR1000 and a surge protector.
OverviewThe COM220 phone modem enables communications between a computer and a Campbell Scientific data logger over a public switched telephone network. A Hayes-compatible modem is required at the computer site. The COM220 connects to the data logger at the field site.
Benefits and FeaturesWide operating temperature range and low power require-ments make it ideal for use at remote sitesSupports communication rates up to 115.2 kbps between mo-dem and data logger. In practice, data transmission through phone lines is generally constrained to 33.6 kbps.Compatible with most Campbell Scientific data loggersOffers both modem enabled (ME) and synchronous device communications (SDC) modesAllows user to set the number of rings before answering call
Technical DescriptionThe COM220 has a CS I/O port, power terminals, screw terminals, and an RJ-11C jack. The data logger connects with the CS I/O port using an SC12 or SC12R-6 cable. The RJ-11C jack is for attach-ing a surge-protected telephone line. Alternatively, the screw terminals (GND, RING, TIP) can be used to connect the COM220 with a phone line using a surge protector.
SE 1 2 3 4 5 6 7 8
H1 2 3 4
LDIFF
H EX1
H LH LL P2P1
12VG
DC ONLYCAUTION
LUGGROUND
POWER IN
WIRING PANELCR1000
PERIPHERAL PORT
RS-232 (Not Isolated)
SN:
CS I/O
MADE IN USA
11109SE 15 1613 1412
HLDIFF
H EX2
H LH LL EX35 6 7 8
SW-1
2
5V 12V
12V
C5
C4
G G G G C1
C2
C3
G GC6
C7
C8
TxCOM1
Rx Tx Rx Tx Rx Tx RxCOM2 COM3 COM4POWER OUT
SDM
G 12V
Burial Phone Cable
Blue = Ring
Blue/White = TipPhone LineTransient Protector(Model 6362 or 2372-01)
SC12 Cable
Earth GroundEarth
Ground Phone Line Transient Protector
Blue/White = Tip
Burial Phone Cable
Blue = Ring SC12 Cable
Hardware Requirements
At Computer Base Station(1) User-supplied computer running PC400 or LoggerNet Data Logger Support Software
(2) 7026 serial cable or equivalent
(3) Customer-supplied, Hayes-compatible modem
(4) Switched telephone network that connects the computer base station with each data logger field site
At Field Site(5) Telephone surge protector if the telephone company has not installed surge protection
(6) COM220 modem
(7) SC12 cable (included with COM220); the SC12R-6 may be purchased if a longer cable is required.
(8) Data logger
(9) Typically an ENC12/14, ENC14/16, or ENC16/18 enclosure
(10) Power supply, usually the data logger’s sealed rechargeable battery recharged with ac power or solar panel
SpecificationsStandards: V.92, K56Flex, V.90, V.34, V.32bis, V32, V23, V22bis, V22, V.21, B212, B103View EU Declaration of Conformity at: www.campbellsci.com/com220Operating Voltage: 12 VdcOperating Temperature: -25° to +50°CCommunication Rate Between Data Logger and COM220 (selected by user): 9600, 38400, 57600, 115200 bps)Operation: Full-duplex over standard analog phone linesDimensions: 16.5 x 2.5 x 6.6 cm (6.5 x 1.0 x 2.6 in)Weight: 0.16 kg (0.35 lb)
RegistrationFCC US: 3A4M508BSM2-T-WIC 2377 A-SM2TWTBR21
Current DrainQuiescent: ~120 μAActive: ~30 mA
© 2006, 2019Campbell Scientific, Inc.
February 1, 2019
HayesCompatible
Modem
SurgeProtector
COM210Modem
Datalogger
Environmental Enclosure
SC12
Cable
Modem
Cable
Standard TelephoneLine
3
4
57
6 8
9
2
COM220 Modem
1
Data Logger