HP eStation Zeen Motherboard ReplacementThis guide is used to replace the Motherboard of the HP eStation Zeen

Written By: dalton hale

HP eStation Zeen Motherboard Replacement Draft: 2018-09-30Guide ID: 71792 -

This document was generated on 2019-09-19 02:53:05 PM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 7

INTRODUCTION

Replacing the motherboard of the HP eStation Zeen is rated a difficult repair, however anyone withpatients can do it. The largest challenges for making this repair is paying attention to details andusing a light touch. There are screws to keep track of and multiple connections to unfasten andreconnect, but when taking the time to follow steps closely it is no more complex than replacing the 9volt battery in most smoke detectors.

TOOLS:Metal Spudger Set (1)iFixit Opening Tools (1)Tweezers (1)Heavy-Duty Spudger (1)Phillips #0 Screwdriver (1)

HP eStation Zeen Motherboard Replacement Draft: 2018-09-30Guide ID: 71792 -

This document was generated on 2019-09-19 02:53:05 PM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 7

Step 1 — Motherboard

Remove the screw caps using the metal spudger.

Remove the four 6mm Phillips screws using the Phillips #0 screwdriver.

Step 2

Unclip each side of the back cover by inserting the plastic opening tool and sliding it along theedge.

Remove the back panel by lifting the panel away from the device.

HP eStation Zeen Motherboard Replacement Draft: 2018-09-30Guide ID: 71792 -

This document was generated on 2019-09-19 02:53:05 PM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 7

Step 3

Disconnect battery clip with plasticopening tool.

The clip is very fragile.

Step 4

Disconnect the speaker terminalwith the plastic opening tool.

The clip is very fragile.

HP eStation Zeen Motherboard Replacement Draft: 2018-09-30Guide ID: 71792 -

This document was generated on 2019-09-19 02:53:05 PM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 7

Step 5

Disconnect the the volume buttonclip with metal spudger tool.

The clip is fragile.

Step 6

Disconnect the ground wire from themotherboard with tweezers.

HP eStation Zeen Motherboard Replacement Draft: 2018-09-30Guide ID: 71792 -

This document was generated on 2019-09-19 02:53:05 PM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 5 of 7

Step 7

Remove the two 6mm Phillips screws with Phillips #0 screwdriver.

Step 8

Pry off the clips that hold the motherboard down with the plastic spudger.

HP eStation Zeen Motherboard Replacement Draft: 2018-09-30Guide ID: 71792 -

This document was generated on 2019-09-19 02:53:05 PM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 6 of 7

To reassemble your device, follow these instructions in reverse order.

Step 9

Lift motherboard up to expose the ribbons on the back.

Lift the grey tabs to disconnect the ribbons with plastic spudger.

HP eStation Zeen Motherboard Replacement Draft: 2018-09-30Guide ID: 71792 -

This document was generated on 2019-09-19 02:53:05 PM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 7 of 7