how to test scr with dmm
DESCRIPTION
how to test scr with testerTRANSCRIPT
HOW TO TEST SCR WITH DMM? – SELECT DIODE MODE IN DIGITAL MULTIMETER. STEP-1.
Connect positive test lead to cathode Negative test lead to Anode= DMM READING Shows OL or 1 or open.
STEP-2.
Connect Negative test lead to cathode positive test lead to Anode= DMM READING SHOWS OL or 1 or open
positive test lead to Gate = .235V DDM READING = 235 mV. (This Gate voltage is very important) otherwise the short of open.
STEP-3.
Connect positive test lead to cathode
Negative test lead to Anode= DMM READING SHOWS OL or 1 or open
STEP-4.
Connect Negative test lead to cathode positive test lead to Anode= DMM READING SHOWS OL or ‘1’ or open (MEANS
OVER LOAD) the condition is GOOD.
Verification: If you get reading in forward bias as 0000 or OL or 1 or open and in reverse bias as 0000 (or) low values the device can be FAULTY and needs replacement.