7/23/2019 How to Check RBS Type via WinFiol

1/4

How to check RBS type:

Step 1:

Launch the corresponding BSC;

Example-1:

Step 2:

Use RXTC Command to !nd out the corresponding T":

Example-#:

Result: Each o$ T" %& and T" '( can )e used to chec* the RBS t+pe,

Hint 1: $ .e can assume that there is onl+ one t+pe o$ RBS in the site/ )elo. 0eri!cationneeds to )e done $or onl+ one cell o$ the site/ other.ise/ i$ dierent RBS t+pes ma+ exist in

the site/ then the 0eri!cation needs to )e done $or all cells 2all T"s3,

Hint 2: t is possi)le to understand the num)er o$ ca)inets o$ each site )+ counting the

num)er o$ assigned T"s $or all cells o$ the site, n this case/ a)o0e mentioned command

should )e run $or all cells o$ the site,

Example-4:

n )elo. example a$ter chec*ing all cells/ .e !nd out that 4 T"s are assigned to the site and

hence 4ca)inets exist there, 5hile i$ .e 6ust chec* cell7 $or example/ .e ma+ conclude that

# ca)inets are there .hich is not correct,

8ote: Calculation o$ RBS %(((s ca)inets are not li*e a)o0e, t depends on the con!guration

o$ site,

7/23/2019 How to Check RBS Type via WinFiol

2/4

Step 3:

Use RX9 2on C3 together .ith identi!ed T" num)er to !nd out the ca)inet t+pe, The

ca)inet t+pe/ or the t+pe o$ XU/ 9U/ U/ etc, is indicated under RUL

7/23/2019 How to Check RBS Type via WinFiol

3/4

Example-=:

Example->:

7/23/2019 How to Check RBS Type via WinFiol

4/4

Example-%:

Example-':

E8,