Pattern may be downloaded for personal use only. No electronic or printed reproduction permitted without the prior written consent of Meredith Corporation. ©Meredith Corporation 2020. All rights reserved.

1AllPeopleQuilt.com

PROJECT BROUGHT TO YOU BY:

PROJECT: Give ThanksPair piecing and appliqué for

an autumn-inspired table runner.DESIGNER: Kim Christopherson of Kimberbell Designs (kimberbelldesigns.com)

Pattern may be downloaded for personal use only. No electronic or printed reproduction permitted without the prior written consent of Meredith Corporation. ©Meredith Corporation 2020. All rights reserved.

2AllPeopleQuilt.com

PROJECT BROUGHT TO YOU BY:

square including seam allowances. Using the same prints, repeat to make four matching triangle-squares total.

3) Using remaining marked assorted tan print squares and brown or black print 27⁄8" squares, repeat Step 2 to make four sets of four matching triangle-squares total.

4) Referring to Diagram 2, lay out eight assorted rust print 21⁄2" squares (two from each print), and eight triangle-squares (two from each set of matching triangle-squares) in four horizontal rows; note direction of seam lines in triangle-squares.

5) Sew together pieces in each row. Join rows to make a star block (Diagram 3). The block should be 81⁄2" square including seam allowances.

6) Repeat steps 4 and 5 to make a second star block.

ASSEMBLE APPLIQUÉD BLOCKS1) Tape Full-Size Embroidery Pattern

on page 5 to a light box or bright window. Center cream dot 81⁄2" square atop pattern; tape in place.

2) Using a fine-point water-soluble pen, trace embroidery design onto fabric to make embroidery foundation (Diagram 4). Secure embroidery foundation in embroidery hoop if desired.

3) Using two strands of brown embroidery floss and embroidery needle, backstitch on marked lines to make embroidered square.

To backstitch, from back of fabric pull needle up at A (Backstitch Diagram). Insert it back into fabric at B, and bring it up at C. Push it down again at D, with no gaps between stitches, and continue in same manner.

TABLE RUNNERFinished size: 81⁄2×241⁄2"

Finished blocks: 8" square

MATERIALSYardages and cutting instructions are based on 42" of usable fabric width.

o 4—4×7" rectangles assorted tan prints (star blocks)

o 4—4×7" rectangles assorted brown and black prints (star blocks)

o 4—6" squares assorted rust prints (star blocks)

o 9" square cream dot (embroidery foundation)

o 5" square gold stripe (leaf appliqués)

o 2×4" rectangle each of orange print and brown-and-gold plaid (leaf appliqués)

o 2×4" rectangle tan vine print (acorn appliqués)

o Scrap of solid brown (acorn appliqués)

o 1⁄4 yard black-and-orange print (binding)

o 1⁄2 yard backing fabric

o 15×31" batting

o Lightweight iron-on fusible web

o Fine-point water-soluble fabric pen

o Embroidery hoop (optional)

o Embroidery floss: brown

o Embroidery needle

CUT FABRICSCut pieces in the following order. Patterns A–D are on page 5. To use fusible web for appliquéing, complete the following steps.

1) Lay fusible web, paper side up, over patterns. Use a pencil to trace each pattern the number of times indicated in cutting instructions, leaving 1⁄2" between tracings. Cut out each fusible-web shape roughly 1⁄4" outside traced lines.

2) Following manufacturer’s instructions, press each fusible-web shape onto wrong side of designated fabric; let cool. Cut out fabric shapes on drawn lines. Peel off paper backings.

From each assorted tan print, cut:▫ 2—27⁄8" squares

From each assorted brown and black print, cut: ▫ 2—27⁄8" squares

From each assorted rust print, cut:▫ 4—21⁄2" squares

From cream dot, cut:▫ 1—81⁄2" square

From gold stripe, cut:▫ 3 of Pattern A

From each orange print and brown-and-gold plaid, cut:▫ 3 of Pattern B

From tan vine print, cut:▫ 3 of Pattern C

From solid brown, cut:▫ 3 of Pattern D

From black-and-orange print, cut:▫ 2—21⁄2×42" binding strips

ASSEMBLE STAR BLOCKSMeasurements include 1⁄4" seam allowances. Sew with right sides together unless otherwise stated. Press seams in directions indicated by arrows on diagrams. If no direction is specified, press seam toward darker fabric.

1) Use a pencil to mark a diagonal line on wrong side of each assorted tan print 27⁄8" square. (To prevent fabric from stretching as you draw lines, place 220-grit sandpaper under each square.)

2) Layer a marked tan print square atop a brown or black print 27⁄8" square. Sew together with two seams, stitching 1⁄4" on each side of drawn line (Diagram 1). Cut apart on drawn line and press open to make two triangle-squares. Each triangle-square should be 21⁄2"

Pattern may be downloaded for personal use only. No electronic or printed reproduction permitted without the prior written consent of Meredith Corporation. ©Meredith Corporation 2020. All rights reserved.

3AllPeopleQuilt.com

PROJECT BROUGHT TO YOU BY:

4) Referring to Diagram 5, arrange A–D appliqué pieces on embroidered square. Fuse appliqués in place following manufacturer’s instructions.

5) Using light brown thread, machine-blanket-stitch around edges of each appliqué to make appliquéd block. The appliquéd block should be 81⁄2" square including seam allowances.

ASSEMBLE TABLE RUNNER TOP1) Referring to Table Runner

Assembly Diagram, lay out appliquéd block between star blocks as shown.

2) Sew together blocks to complete table runner top. Press seams toward star blocks.

FINISH TABLE RUNNER1) Layer table runner top, batting, and

backing; baste.

2) Quilt as desired. Mary Christensen machine-quilted curved lines in the star points and center of each star block. She quilted a large stipple in the cream dot background of the appliquéd block and added a vein to each of the leaf appliqués.

3) Bind table runner with black-and-orange print binding strips.

Pattern may be downloaded for personal use only. No electronic or printed reproduction permitted without the prior written consent of Meredith Corporation. ©Meredith Corporation 2020. All rights reserved.

4AllPeopleQuilt.com

PROJECT BROUGHT TO YOU BY:

DIAGRAM 1

Quilts and More Fall 2016CMR: Give ThanksDiagram 1M Steenson 04/11/2016100589562

DIAGRAM 2

21⁄2"sq.

Quilts and More Fall 2016CMR: Give ThanksDiagram 2M Steenson 04/11/2016100589563

DIAGRAM 3

Quilts and More Fall 2016CMR: Give ThanksDiagram 3M Steenson 04/11/2016100589564

81⁄2"sq.

DIAGRAM 4

Quilts and More Fall 2016CMR: Give ThanksDiagram 4M Steenson 04/11/2016100589565

AD

FC

EG

B

BACKSTITCH DIAGRAM

Quilts and More Fall 2016CMR: Give ThanksBackstitchM Steenson 04/11/2016100589566

DIAGRAM 5

A

A

A

BB

B

B

BC

C

C

D

D

D

B

Quilts and More Fall 2016CMR: Give ThanksDiagram 5M Steenson 04/11/2016100589567

TABLE RUNNER ASSEMBLY DIAGRAM

Quilts and More Fall 2016CMR: Give ThanksTable Runner AssemblyM Steenson 04/11/2016100589568

Pattern may be downloaded for personal use only. No electronic or printed reproduction permitted without the prior written consent of Meredith Corporation. ©Meredith Corporation 2020. All rights reserved.

5AllPeopleQuilt.com

PROJECT BROUGHT TO YOU BY:Project: Give Thanks

Pattern may be downloaded for personal use only. No electronic or printed reproduction permitted without the prior written consent of Meredith Corporation. ©Meredith Corporation 2016. All rights reserved. 1

American Patchwork & Quilting | Quilt Sampler | Quilts and More

When printing a downloadable pdf, set Page Scaling preference to NONE to print patterns at 100%. Do NOT "Shrink to Fit" or "Fit to Printable Area."

This box should measure 1".

GIVE THANKSFULL-SIZE EMBROIDERY PATTERN

GIVE THANKSPATTERN A

GIVE THANKSPATTERN C

GIVE THANKSPATTERN B

D

Quilts and More Fall 2016CMR: Give ThanksPattern PackM Steenson 04/11/2016100589569

When printing a downloadable pdf, set Page Scaling preference to NONE to print patterns at 100%. Do NOT "Shrink to Fit" or "Fit to Printable Area."

This box should measure 1 ".