for excavators e-mail: [email protected] t: ...€¦ · ghedini ing. fabio & c. snc – via...
TRANSCRIPT
Internet: www.ghedini.it
e-mail: [email protected]
tel. +39 0532 857373
fax +39 0532 857873
HHyyddrraauulliicc bbuusshh ccuutttteerrss
DDKK sseerriieess
ffoorr eexxccaavvaattoorrss
ffrroomm 77 ttoo 2200 ttoonnss
GHEDINI ing. FABIO
Catalogue nr.99810
Ghedini ing. Fabio & C. snc – Via Canne, 47 – I 44048 S. M. Codifiume (Ferrara) Italy
tel. +39 0532 857373 – fax. +39 0532 587373 – e-mail: [email protected]
The hydraulic bush cutters DK series have been engineered to be used on excavators with a maximum operational weight ranging from around 7 t to 20 t. Three models with an operational width of 130, 160 and 190 cm are available. The brackets are interchangeable.
The bidirectionality of the rotor and the absence of the support roller let it work in both directions. Both entries of the hydraulic engine should be connected to an hydraulic power plug like a “double acting”. In the meantime the ¼ G drain tube should be directly connected to the tank.
Technical specifications table of the bush cutter DK series
Model
Minimum oil
flow rate
required
Max.
pressure
Operational
width
L
Weight
Weight of the excavator
[L/min] [bar] [mm] [kg] [tons]
DK 13 75 250 1.300 500 7 – 11
DK 16 90 250 1.600 600 10 – 15
DK 19 100 250 1.900 700 14 – 20
The hydraulic bush cutter DK series is equipped with a couple of “Y” shaped blades and a third one located in the middle, which allows it to reduce all the treated material to fine grains.