fab glass frameless rectangle mirror installation manual · 2018-12-24 · drill/driver level tape...
TRANSCRIPT
F A B G L A S SA N D M I R R O R
Fab Glass Frameless Rectangle MirrorInstallation Manual
www.fabglassandmirror.com Call: +1 888-474-2221 Fax: (614)-334-4919
Office Timing: 8:30 - 18:00 EST [email protected]
Drill/Driver Level Tape Measure Screw Driver Hammer Lead Pencil
Thank you for your purchase! It is our desire to make your entire experience from purchase to installation as easy as possible. We ask that you read each step of this installation manual thoroughly to ensure proper installation of your new Mirror. Our installation techniques are very important. Installing your Mirror in any manner other than the steps outlined in this manual may lead to structural failure of your Mirror.
Safety Backing Mirror:A single sided woven tape is laminated onto the back of the mirror for security reasons if ever the glass is broken, the adhesive film holds the shattered pieces together, which significantly decreases the risk of injury.
It is your responsibility to see that your Mirror is properly assembled, installed, and cared for. Failure to follow instructions in this manual could result in serious injury. Use this product with Mirror cautions.
Tools Needed
Hardware Included With This Order
CAUTION
Anchor( Qty - 4/6)
Screw( Qty - 4/6)
1
2
3
4
By using your cuttingtool, carefully openthe package andremove the mirror.
On the back side ofthe mirror, use yourpencil to mark thecenter point.
1Page
Measure the distancebetween the centerpoint of the clips andwrite down the result.
Measure the distancebetween the centerpoint of the clips andwrite down the result.
Mirror Back Side
Center Point
5
6
7
8
Hold the mirror againstthe wall where you wantto install it, and markthe wall at the top edgeof the mirror with your pencil.
Using the results fromthe Steps 3 and 4, measuredown from the top edgemark to the center pointbetween the clips andplace another mark,then from that markmeasure out to thecenter of the clip bodyon each side and markthe wall in both spots.
Drill two holes in thewall at the clip bodycenter locations.
Using your drill,insert the anchorbolts in the holes.
Anchor
2Page
12
Hang the mirror on thewall by inserting thescrew heads into theclips, and press gentlyagainst the bottom ofthe mirror to attachthe sticky pads firmlyto the wall.
Now Fix the clip holeson screws
9
10
13
Leave ¼ “ of spacebetween the walland the screw head.
Now install the screwin the anchor withyour drill.
3Page
Distance From Wall
Wall(Side View)
Space fromwall
Congratulations!You have successfully installed yourframeless rectangle mirror. Enjoy!