elvarex measuring for † elvarex soft seamless … for medical gloves: procedure: the measurements...

1
Measuring for medical gloves: Procedure: The measurements to be taken after edema removal depend on the type of treatment required for the hand. During the measurements the patient sits with the arm slightly angled and the palm of the hand facing upwards on the table. Preconditions: The extremity should be largely free of edema before measuring for the glove. The degree of edema can be checked before measuring by pressing firmly with the finger: if edema is present, pitting is observed which does not 1. Determine measurement point A on the inner and outer edge of the hand at the level of the 5th MCP (little finger web space). 2. Measurement point B is located on the palm of the hand at the level of the web of the thumb. Tip for measurement point B: To determine measurement point B place a JOBST Flexi-Card at a right angle to the web space of the thumb and across the palm of the hand. 3. Measurement point C is located at the distal flexion crease. 4. Measurement point C 1 depends on the shape of the forearm and is about 3-5 cm above C. This is where the glove should end. 5. Measure circumference A with the hand laid flat. 6. Measure circumference B with the hand laid flat. 7. Measure circumference C at the wrist. Important! Do not pull the tape measure tight. 8. Measure circumference C 1 at the mark made previously (measurement not required for an arm sleeve A-G 1 or C-G 1 ). 9. Measure length A-B on the inside surface of the hand. 10. Measure length A-C on the inside surface of the hand. 11. Measure length A-C 1 on the inside surface of the hand and arm. 1. Determine finger length from X (web) to the variable endpoint Z (desired end of glove finger, usually no longer than nail bed). Tip: Using a JOBST Flexi-Card placed in the web, the finger length X-Z can be determined in a single step. 2. Determine circumference Z. 3. Measure circumference X at the base of the finger. Follow the same procedure to determine the circumferences and lengths of all the fingers. immediately disappear. If this is the case the patient should not be measured for compression garments and the extremity should first be decongested (e.g. by compression bandaging and manual lymph drainage). The following auxiliary materials are required: Marker pen, ball point pen, tape measure, size sheet Measuring for finger portions Finally, take the length measurements for the glove: Then measure the circumferences: First determine the measurement points: • Elvarex ® • Elvarex ® Soft Seamless Comfort, Health and Style! BSN medical Inc. 5825 Carnegie Blvd. Charlotte, NC 28209-4633 Tel. (+1) 704 554 9933 Fax (+1) 800 835 4325 www.jobst.com To order toll-free: (+1) 800 537 1063 60865 RN © 2011 BSN medical Inc. REV 08/11

Upload: hakhanh

Post on 24-May-2018

214 views

Category:

Documents


1 download

TRANSCRIPT

Measuring for medical gloves:

Procedure:

The measurements to be takenafter edema removal depend on the type of treatmentrequired for the hand. Duringthe mea surements the patientsits with the arm slightly angledand the palm of the hand facingupwards on the table.

Preconditions:

The extremity should be largelyfree of edema before measuring for the glove.The degree of edema can bechecked before measuring bypress ing firmly with the finger: if edema is present, pitting isobserved which does not

1. Determine measurement point A on theinner and outer edge of the hand at thelevel of the 5th MCP (little finger webspace).

2. Measurement point B is located on thepalm of the hand at the level of the webof the thumb.

Tip for measurement point B: To determinemeasurement point B place a JOBST Flexi-Card at a right angle to the web space of the thumband across the palm of the hand.

3. Measurement point C is located at thedistal flexion crease.

4. Measurement point C1 depends on theshape of the forearm and is about 3-5 cm above C. This is where the gloveshould end.

5. Measure circumference A with the handlaid flat.

6. Measure circumference B with the handlaid flat.

7. Measure circumference C at the wrist.Important! Do not pull the tape measuretight.

8. Measure circumference C1 at the markmade previously (measurement notrequired for an arm sleeve A-G1 or C-G1).

9. Measure length A-B on the inside surfaceof the hand.

10. Measure length A-C on the inside surfaceof the hand.

11. Measure length A-C1 on the inside surfaceof the hand and arm.

1. Determine finger length from X (web) tothe variable endpoint Z (desired end ofglove finger, usually no longer than nailbed). Tip: Using a JOBST Flexi-Card placedin the web, the finger length X-Z can bedetermined in a single step.

2. Determine circumference Z. 3. Measure circumference X at the base ofthe finger. Follow the same procedure todetermine the circumferences and lengthsof all the fingers.

immediately disappear. If thisis the case the patient shouldnot be measured forcompression garments and theextremity should first bedecongested (e.g. bycompression bandaging andmanual lymph drainage).

The following auxiliary materials are required:

Marker pen, ball point pen, tape measure, size sheet

Measuring for finger portions

Finally, take the length measurements for the glove:

Then measure the circumferences:

First determine the measurement points:

• Elvarex®

• Elvarex® SoftSeamless

Comfort, Health and Style!BSN medical Inc. 5825 Carnegie Blvd. Charlotte, NC 28209-4633Tel. (+1) 704 554 9933 Fax (+1) 800 835 4325 www.jobst.comTo order toll-free: (+1) 800 537 1063

60865 RN © 2011 BSNmedical Inc. REV 08/11

mataram
Typewritten Text
mataram
Typewritten Text