EB Gigabit PoE+ Injector

The EB Gigabit PoE+ Injector is a rugged network-agnostic solution that provides high speed data and electrical high power connections for devices used in tactical military communication environments.

EB Gigabit PoE+ Injector combines data and power supply over a single Ethernet cable without a costly need to replace the existing military communications infrastructure. The EB Gigabit PoE+ Injector is fully MIL

compliant and is well suited for high vibration environments like vehicle installations. This unique solution can easily make communication devices PoE-ready.

BenefitsXX Provides gigabit throughput for high speed data devices

XX Rugged network-agnostic solution

XX High power supply for PoE+ devices

XX High vibration environments, including tracked vehicles

Elektrobit (EB), Tutkijantie 8, FI-90590 Oulu, Finland Tel. +358 40 344 2000 defense@elektrobit.com www.elektrobit.com

Copyright 2014 Elektrobit (EB). All rights reserved. Information contained herein is subject to change without notice. EB retains ownership and all other rights in the material expressed in this document. Any reproduction of the content of this document is prohibited without the prior written permission of EB.

EB Gigabit PoE+ Injector

InterfacesXX 10/100/1000 Base-T Dual Ethernet

802.3at Type 2 (802.3af)

10/100/1000 Mixed DC & Data, Mode A configuration

Connector: Bernier CMA 7W22PM (22-pin)

PoE: Maximum output power delivered 30W, 600mA @ 50 57 Vdc

Single connector interface for Ethernet and PoE

XX DC input

Input voltage range 10 32 VDC

Connector: Amphenol 62GB-5024-1402PB

Technical specificationXX Operating temperature range 40 C/+55 C

XX Dimensions L 146 W 90 H 43 mm

XX Weight 750 g

Certificates and standardsXX MIL-STD-810G

High temperature: Test method 501.5 Procedure I, II and III

Low temperature: Test method 502.5, Procedure I and II

Temperature shock: Test method 503.5 Procedure I-C

Solar Radiation: Test method 505.5 Procedure I and II

Humidity: Test method 507.5 Procedure II

Leakage (immersion): Test method 512.5, procedure I

Vibration: Test method 514.6, Category 20: Ground vehicles-Ground mobile, Procedure I: General vibration

Shock: Test method 516.6 procedure I and IV

XX MIL-STD-461F Ground, Army

CE102, CS101, CS114, CS115, CS116, RE102, RS103

XX MIL-STD-1275D (Vehicle equipment, characteristics of 28Volt DC)

XX CE-EMC:

IEC6100-6-2 (ESD, EFT, Surge, Conducted Susceptibility, Radiated Susceptibility)

IEC61000-6-3 (Radiated Emission, Conducted Emission)

XX EU REACH Compliance

XX EU RoHS Compliance

XX ISO9001 and AQAP 2110 for quality