Download - Gsm message display
![Page 1: Gsm message display](https://reader036.vdocuments.mx/reader036/viewer/2022081505/554a3fa6b4c9055a408b4d9e/html5/thumbnails/1.jpg)
GSM BASED NOTICE BOARD ON LCD DISPLAY
![Page 2: Gsm message display](https://reader036.vdocuments.mx/reader036/viewer/2022081505/554a3fa6b4c9055a408b4d9e/html5/thumbnails/2.jpg)
INTRODUCTION• In this project we are using GSM Modem
to receive SMS from user mobile and display the same message on LCD.
• GSM is interfaced with 89S52 Microcontroller through Max232 interface. It is connected to controller logic board using serial cable.
• We are using 16*2 LCD Message Display.
![Page 3: Gsm message display](https://reader036.vdocuments.mx/reader036/viewer/2022081505/554a3fa6b4c9055a408b4d9e/html5/thumbnails/3.jpg)
WORKING PRINCIPLE• The GSM Modem is first properly initialized and then it
checks for modem connectivity. The program is written in microcontroller to perform this task.
• After that user has to send SMS to GSM modem and message contents are finally displayed on the LCD. The microcontroller used in this project is Atmel 89S52.
• The data is sent to microcontroller through MAX232 interface. MAX232 acts as logic level shifter IC. It means, it converts TTL Logic Level to RS-232 and vise versa.
![Page 4: Gsm message display](https://reader036.vdocuments.mx/reader036/viewer/2022081505/554a3fa6b4c9055a408b4d9e/html5/thumbnails/4.jpg)
HARDWARE COMPONENTS
• 7805 Regulator • 89S52 MCU• MAX232 Interface• GSM Modem• Serial Cable• 16*2 LCD Display
![Page 5: Gsm message display](https://reader036.vdocuments.mx/reader036/viewer/2022081505/554a3fa6b4c9055a408b4d9e/html5/thumbnails/5.jpg)
GSM SPECIFICATIONS :~
• Frequency Used : 890 to 960 Mhz• Uplink Frequency : 890 to 915 Mhz• Downlink Frequency: 935 to 960 Mhz• Channel Bandwidth: 200 Mhz• No. Of Channels: 124• Modulation Used GMSK• Mobile Station Power Output: 0.8w,2.5w,8w• FDM-TDMA Technology is used in GSM.
![Page 6: Gsm message display](https://reader036.vdocuments.mx/reader036/viewer/2022081505/554a3fa6b4c9055a408b4d9e/html5/thumbnails/6.jpg)
![Page 8: Gsm message display](https://reader036.vdocuments.mx/reader036/viewer/2022081505/554a3fa6b4c9055a408b4d9e/html5/thumbnails/8.jpg)
Power supplyThe microcontroller operating voltage is +5V DC.
The following components are used to construct the power supply circuit.
![Page 9: Gsm message display](https://reader036.vdocuments.mx/reader036/viewer/2022081505/554a3fa6b4c9055a408b4d9e/html5/thumbnails/9.jpg)
Power Supply Description:
230V AC supply is given to the step down transformer .
The output of the step down transformer is given to bridge rectifier.
The bridge rectifier is formed with diodes. The bridge rectifier converts the AC voltage into DC voltage.
But the output DC Voltage contains some AC component (ripples). So we use capacitors as a filter for removing ripples.
The output DC Voltage is given to the positive voltage regulator LM7805 . So the output of the regulator will be the regulated +5V DC.
To indicate the condition of the circuit we place LED at the end of the circuit.
![Page 10: Gsm message display](https://reader036.vdocuments.mx/reader036/viewer/2022081505/554a3fa6b4c9055a408b4d9e/html5/thumbnails/10.jpg)
Liquid Crystal Display
The most commonly used Character based LCDs are based on Hitachi's HD44780 controller .
Pin Description
The most commonly used LCDs available in the market today are single Line, double Line or four Line LCDs and support at most of 80 characters.
Most LCDs with one controller has 14 Pins and LCDs with two controller has 16 Pins (two pins are extra in both for back-light LED connections).
![Page 11: Gsm message display](https://reader036.vdocuments.mx/reader036/viewer/2022081505/554a3fa6b4c9055a408b4d9e/html5/thumbnails/11.jpg)
LCD Pin Diagram
![Page 12: Gsm message display](https://reader036.vdocuments.mx/reader036/viewer/2022081505/554a3fa6b4c9055a408b4d9e/html5/thumbnails/12.jpg)
Pin description of 16*2 LCD is shown in the table below.
![Page 13: Gsm message display](https://reader036.vdocuments.mx/reader036/viewer/2022081505/554a3fa6b4c9055a408b4d9e/html5/thumbnails/13.jpg)
BLOCK DIAGRAM
AT89S52 MCU
MAX232 INTERFACE
REGULATED POWER SUPPLY
16*2 LCD DISPLAY
GSM MODEM
![Page 14: Gsm message display](https://reader036.vdocuments.mx/reader036/viewer/2022081505/554a3fa6b4c9055a408b4d9e/html5/thumbnails/14.jpg)
at89s52Compatible with MCS ®51 products8Kb of ISP flash memory256x8 bit internal RAM32 Programmable I/O linesThree timer/countersFull duplex UART serial channel
![Page 15: Gsm message display](https://reader036.vdocuments.mx/reader036/viewer/2022081505/554a3fa6b4c9055a408b4d9e/html5/thumbnails/15.jpg)
Features of 89S52
• 8-bit CPU
• 64K Program Memory address space
• 64K Data Memory address space
• 8K bytes of on-chip Program Memory
• 256 bytes of on-chip Data RAM
![Page 16: Gsm message display](https://reader036.vdocuments.mx/reader036/viewer/2022081505/554a3fa6b4c9055a408b4d9e/html5/thumbnails/16.jpg)
Block Diagram
CPU
On-chip RAM
On-chip ROM for program code
4 I/O Ports
Timer 0
Serial PortOSC
Interrupt Control
External interrupts
Timer 1
Timer/Counter
Bus Control
TxD RxDP0 P1 P2 P3
Address/Data
Counter Inputs
![Page 17: Gsm message display](https://reader036.vdocuments.mx/reader036/viewer/2022081505/554a3fa6b4c9055a408b4d9e/html5/thumbnails/17.jpg)
Pin diagram of at89s52
![Page 18: Gsm message display](https://reader036.vdocuments.mx/reader036/viewer/2022081505/554a3fa6b4c9055a408b4d9e/html5/thumbnails/18.jpg)
The simplest connection between a PC and microcontroller requires a minimum of three pins, RxD (receiver, pin2), TxD (transmitter, pin3) and ground (pin5) of the serial port of computer.
![Page 19: Gsm message display](https://reader036.vdocuments.mx/reader036/viewer/2022081505/554a3fa6b4c9055a408b4d9e/html5/thumbnails/19.jpg)
SOFTWARE TOOLS
• Embedded C Code
• Keil Compiler
• ucFlash
![Page 20: Gsm message display](https://reader036.vdocuments.mx/reader036/viewer/2022081505/554a3fa6b4c9055a408b4d9e/html5/thumbnails/20.jpg)
Advantages & applications
• Low cost• Flexible• Low power consumption
APPLICATIONS:• Can be used in industries • Can be used in Nuclear plants• Can be used in mines
![Page 21: Gsm message display](https://reader036.vdocuments.mx/reader036/viewer/2022081505/554a3fa6b4c9055a408b4d9e/html5/thumbnails/21.jpg)
reference
• “The 8051 Microcontroller and Embedded Systems” by Muhammad Ali Mazidi and Janice Gillispie Mazidi, Pearson Education.
• ATMEL 89S52 Data sheets
![Page 22: Gsm message display](https://reader036.vdocuments.mx/reader036/viewer/2022081505/554a3fa6b4c9055a408b4d9e/html5/thumbnails/22.jpg)
THANK YOU