Download - Air Conditioning Combination
![Page 1: Air Conditioning Combination](https://reader034.vdocuments.mx/reader034/viewer/2022042706/577cc15e1a28aba71192c620/html5/thumbnails/1.jpg)
ENVIRONMENTAL CONTROL SYSTEM
PILATUS PC-7 MKII
LT M AHMAD KHUZAIREY BIN MD NASIR TUDM
![Page 2: Air Conditioning Combination](https://reader034.vdocuments.mx/reader034/viewer/2022042706/577cc15e1a28aba71192c620/html5/thumbnails/2.jpg)
cooling system
![Page 3: Air Conditioning Combination](https://reader034.vdocuments.mx/reader034/viewer/2022042706/577cc15e1a28aba71192c620/html5/thumbnails/3.jpg)
INTRODUCTION & DESIGN PHILOSOPHY• The PC-7 MkII cooling system is a vapour
compression cycle system that uses a refrigerant to absorb the heat from the cockpit air.
![Page 4: Air Conditioning Combination](https://reader034.vdocuments.mx/reader034/viewer/2022042706/577cc15e1a28aba71192c620/html5/thumbnails/4.jpg)
Main components
• The cooling system, as installed on the PC-7 MkII, consists of:- A compressor- A condenser and blower fan- A receiver/dryer- Two evaporators- Two ECS control panels- Two maintenance valve switch assemblies- Refrigerant hoses and pipe fittings
![Page 5: Air Conditioning Combination](https://reader034.vdocuments.mx/reader034/viewer/2022042706/577cc15e1a28aba71192c620/html5/thumbnails/5.jpg)
Main components
![Page 6: Air Conditioning Combination](https://reader034.vdocuments.mx/reader034/viewer/2022042706/577cc15e1a28aba71192c620/html5/thumbnails/6.jpg)
Normal Operation Cooling Process
With the cooling system switched ON in the front cockpit (engine running), the compressor compresses the low pressure refrigerant gas and turns it into a high pressure refrigerant vapour
The compressed/vaporised refrigerant is pumped to the condenser where it is cooled and condensed into a high-pressure liquid
From the condenser the refrigerant moves to the receiver/dryer where it is dried and filtered
From the receiver dryer the refrigerant liquid flows to the evaporator expansion valves, that control the refrigerant flow rates
Blower fans circulate cockpit air through the evaporator heat exchangers which extracts the heat from the air. The heat is absorbed by the refrigerant in the evaporators and the refrigerant is again vaporised
The refrigerant returns to the compressor and the cooling cycle is repeated
![Page 7: Air Conditioning Combination](https://reader034.vdocuments.mx/reader034/viewer/2022042706/577cc15e1a28aba71192c620/html5/thumbnails/7.jpg)
Cockpit Airflow• Two torso outlets, on the centre console in
each cockpit, allows for the distribution of cooled air through the cockpit
• An air distribution control lever, on the centre console, directs air to the various outlets
![Page 8: Air Conditioning Combination](https://reader034.vdocuments.mx/reader034/viewer/2022042706/577cc15e1a28aba71192c620/html5/thumbnails/8.jpg)
Summary The Cooling System can be switched on from
the front Cockpit ECS control panel A refrigerant is cycled through various stages of
the aircraft's cooling system to produce cool air Blower fans controls the rate of flow of cooled
air Torso outlets can be adjusted to control the
volume and direction of cool air
![Page 9: Air Conditioning Combination](https://reader034.vdocuments.mx/reader034/viewer/2022042706/577cc15e1a28aba71192c620/html5/thumbnails/9.jpg)
Malfunctions and Emergency Procedures
• The cooling system in the PC-7 MkII is a vapour compression cycle system
• A refrigerant is cycled through the cooling system where it is cooled to help absorb the warm cabin air
• Cool air is delivered to the cockpit through two torso outlets in each cockpit
• In case of a cooling system failure: Land as soon as possible Climb to higher altitudes for crew comfort if landing within a reasonable time is not possible
![Page 10: Air Conditioning Combination](https://reader034.vdocuments.mx/reader034/viewer/2022042706/577cc15e1a28aba71192c620/html5/thumbnails/10.jpg)
Land as soon as possible
Climb to higher altitudes
Emergency Operations
![Page 11: Air Conditioning Combination](https://reader034.vdocuments.mx/reader034/viewer/2022042706/577cc15e1a28aba71192c620/html5/thumbnails/11.jpg)
heating system
![Page 12: Air Conditioning Combination](https://reader034.vdocuments.mx/reader034/viewer/2022042706/577cc15e1a28aba71192c620/html5/thumbnails/12.jpg)
INTRODUCTION & DESIGN PHILOSOPHY Cockpit heating in the PC-7 MkII is achieved
through a heating ram air system Heat is provided by combining outside ram
air with hot P3 compressor bleed air The heated air is delivered in the cockpit
through ducts to foot and de-fogging outlets
![Page 13: Air Conditioning Combination](https://reader034.vdocuments.mx/reader034/viewer/2022042706/577cc15e1a28aba71192c620/html5/thumbnails/13.jpg)
Section SummaryCockpit heating in the PC-7 MkII is achieved
through a heating ram air system that mixes outside ram air with hot air from the engine P3 compressor section.
![Page 14: Air Conditioning Combination](https://reader034.vdocuments.mx/reader034/viewer/2022042706/577cc15e1a28aba71192c620/html5/thumbnails/14.jpg)
Main Components
![Page 15: Air Conditioning Combination](https://reader034.vdocuments.mx/reader034/viewer/2022042706/577cc15e1a28aba71192c620/html5/thumbnails/15.jpg)
Main Components
• The heating ram air system, as installed on the PC-7 MkII, consists of:- A butterfly valve- A bleed air heater with integral flow regulator- A temperature limiting switch- A shut-off valve- A ram air temperature control knob- A system of ducts and control levers to distribute the air
![Page 16: Air Conditioning Combination](https://reader034.vdocuments.mx/reader034/viewer/2022042706/577cc15e1a28aba71192c620/html5/thumbnails/16.jpg)
Normal Operation
Heating Process• The ram air temperature control knob on the ECS
control panel (labelled OFF / RAM AIR / HEAT) controls the flow and temperature of air through the heating ram air system.
• Heating and ram air can only be selected ON / OFF from the front cockpit ECS control panel. The panel also contains the cooling system COOL and FAN toggle switches. (Airflow volume and direction can be controlled individually from both cockpits).
![Page 17: Air Conditioning Combination](https://reader034.vdocuments.mx/reader034/viewer/2022042706/577cc15e1a28aba71192c620/html5/thumbnails/17.jpg)
- Ram air is blocked by the butterfly valve when the ram air temperature control knob is in the OFF position.- Selecting RAM AIR on the ECS control panel will open the butterfly valve and allow only outside fresh ram air to enter the system through the foot and de-fogging outlets.
![Page 18: Air Conditioning Combination](https://reader034.vdocuments.mx/reader034/viewer/2022042706/577cc15e1a28aba71192c620/html5/thumbnails/18.jpg)
- Selecting the HEAT positions on the ECS control panel energises the flow regulator and allows bleed air to pass the flow regulator and mix with the ram air.
![Page 19: Air Conditioning Combination](https://reader034.vdocuments.mx/reader034/viewer/2022042706/577cc15e1a28aba71192c620/html5/thumbnails/19.jpg)
Air Distribution• An air distribution control lever is located
above the cool air torso outlets, on the centre console of each cockpit
![Page 20: Air Conditioning Combination](https://reader034.vdocuments.mx/reader034/viewer/2022042706/577cc15e1a28aba71192c620/html5/thumbnails/20.jpg)
Firewall Shut-Off T-Handle• The firewall shut-off T-handle, when pulled,
activates the heating ram air system shut-off valve and blocks the flow of air to the cockpits. (The firewall shut-off T-handle also activates the shut-off valves for the fuel and hydraulic systems)
![Page 21: Air Conditioning Combination](https://reader034.vdocuments.mx/reader034/viewer/2022042706/577cc15e1a28aba71192c620/html5/thumbnails/21.jpg)
Malfunctions and Emergency Procedures Emergency Operations
![Page 22: Air Conditioning Combination](https://reader034.vdocuments.mx/reader034/viewer/2022042706/577cc15e1a28aba71192c620/html5/thumbnails/22.jpg)
• If the temperature limiting switch malfunctions and the duct temperature reaches 120°C:- The master caution will be triggered- The OV TEMP caption on the EID will come ON
• In such a case you need to:1. Reset the master caution2. Open the ram air3. Pull the cockpit heating circuit breaker
![Page 23: Air Conditioning Combination](https://reader034.vdocuments.mx/reader034/viewer/2022042706/577cc15e1a28aba71192c620/html5/thumbnails/23.jpg)
Summary Cockpit heating in the PC-7 MkII is achieved through a heating
ram air system that mixes outside ram air with hot air from the engine P3 compressor section
The heating ram air system can be switched on from the front Cockpit ECS control panel
An air distribution control lever allows ram or heated air to be directed to the foot and de-fogging outlets as required
The firewall shut-off T-handle activates the shut-off valve of the heating ram air system, to block the flow of air to the cockpits
In case of an over temperature scenario, reset the master caution switch, open the ram air and pull the cockpit heating circuit breaker
![Page 24: Air Conditioning Combination](https://reader034.vdocuments.mx/reader034/viewer/2022042706/577cc15e1a28aba71192c620/html5/thumbnails/24.jpg)
Any Question??