3

Please read the following instructions and warnings carefully

KEEP THIS INSTRUCTION MANUALAND SAVE FOR FUTURE REFERENCE.

Tool required: Phillips head screwdriver (not included).DO NOT USE POWER TOOLS TO ASSEMBLE.For technical support, contact us at 1 (401) 671-6551.

or www.summerinfant.com/contactFor use with children from

approximately 4 months to 4 yearsAdult assembly required.

4-in-1 SuperSeat®

Sit, Snack & Play!

INSTRUCTION MANUAL

FALL HAZARD: Infants have suffered skull fractures falling while in and from floor seats:

· Use ONLY on the floor.· NEVER use on an elevated surface.· ALWAYS use restraints. Adjust to fit snugly.· NEVER lift or carry child in the product.· Use ONLY with a child that is able to hold their head up unassisted.

· STOP using when child can climb out or walk.· ALWAYS keep child in view while in product.DROWNING HAZARD: Infants have drowned when floor seat has been placed in a bath tub or pool.

· NEVER use in or near water.

Children have suffered head injuries, including skull fractures, after falling with or from booster seats.

· Check that booster seat is securely attached to adult chair before each use.

· Always use restraints until child is able to get in and out of booster seat without help. Adjust to �t snugly.

· Never allow child to push away from table.· Never lift and carry child in booster seat.· Stay near and watch your child during use.· ALWAYS secure BOTH back and seat straps to an adult chair.

· NEVER lift this product with your child in it.· NEVER leave child unattended and without supervision.

· Prevent serious injury or death. Do not use in motor vehicles.

· NEVER use this product as a car seat or bath seat, on a table or counter top, stool, swivel chair, folding chair, unstable chair or any chair where the straps cannot secure it properly.

· Minimum dimensions of adult chair that the booster seat shall be attached to: Seat width 18 in. and depth 18 in., and the seat backrest height is at least 8 in. tall.

· ALWAYS use product with support insert securely installed, during all modes of use.

· Until child is able to get in and out of the booster seat without help (about 2½ years old), the child should be secured in the booster seat at all times by the restraining system. The tray is not designed to hold the child in the chair.

• Use this product only with children capable of sitting upright unassisted.

· Check that both the floor and seat of the chair are level before installing the booster seat.

· Prevent finger injury: Keep child away from chair when installing the tray.

· When in booster seat mode, use only feeding tray section and remove activity tray sections.

· Once installed, check the security and position of the booster seat.

· Do not use this booster unless all components are correctly fitted and adjusted.

· Discontinue use of the product if damaged, broken, or disassembled.

PREVENT FALLS: ALWAYS USE ADULT CHAIR STRAPS when using product on elevated surfaces as a booster seat.

Infant Floor/Support Seat Use:

Booster Seat Use:

Booster Seat Use Continued:

WARNING WARNING

WARNING

C

D

E

M

A

Seat BaseA

Fabric Seat B Bead Toy

I

C Support Insert

Plastic Support Insert

Backrest

D

Spinner Ball Tray

E

Shape Sorter Toys (2)

J

Center Tray

F

Feeding Tray

H Shape Sorter Tray

G

Spin Toys (2)

K

L

Adult Chair Straps (4)M

Long Screws (4)N

O Short Screws (4)

B

components:

I K

HFG

Activity Tray:

Hardware:

Seat Base will come preassembled with: Child Restraint Straps, Fabric Seat, Plastic Support Insert, and Support Insert.

x4 x4

N O

LJ

assembly: assembly: assembly: assembly:

click!

Press the

backrest down

into the seat

base. It will lock

into place.

1

2

Flip the seat over.

Insert and fasten

the 2 long screws.

N

x 2

Note: Toddlers may not need the support insert. Remove insert from straps if desired.

Note: Ensure backrest and seat base are fully connected. Test stability and connection points before use.

!

!

Note: Bottom front T-straps will be attached prior to first use. To re-attach fabric seat if you need to remove and machine wash it, rethread T-straps through the slots.

!

Helpful Hint: If possible, use a long screwdriver on the two front screw locations.

!

x 2

click!

Align the 2 screw holes in the plastic support insert to the those in the front base. Using 2 long screws, attach from

the underside of the base.

3 N

x 2

Helpful Hint: This step may be easiest with the seat flipped over. You may need to pull the fabric back slightly to access the screw holes.

!

Thread the three

T-straps on the back of the

fabric seat into the slots on

the backrest.

4

x 3

Note: Pull up to ensure the straps are fully inserted. They should not pull out of the slots.

!

5

Insert the two

plastic fasteners

on the underside

of the fabric seat

into the top of

the seat frame.

x 2

x 2

6

x 2

Insert the four plastic fastenersinto the keyhole slots on the front of the seat frame. Slide

fasteners to lock.

Use 4 short screws

to assemble the

activity tray (F,G,H).

7O

x 4

H

G

F

Connect toys (J and L)

by inserting them

onto the activity tray.

press! press!

8

Slide activity tray into

track around the backrest.9

Connect feeding tray

to activity tray.

click!

Note: It may help to place one hand on the back of the activity tray. Pull on all sides of the tray to ensure that it is fully connected.

!

10

click!

2 4

5 6 7 8

assembly:

x 2

11

Note: Pull up to ensure the straps are fully inserted. They should not pull out of the slots.

!

Connect the square and triangle sorter toys (K)

by threading the T-straps through the slots

in the activity tray.

FINISHED!12

modes of use: modes of use:

Positioner/Support Seat

Activity Center

Feeding SeatUse on the �oor or on an adult

chair (chair straps included).

Booster SeatUse on an adult chair

(chair straps included).

Fabric insert supports baby’s waist & back. Use for babies just

learning to sit up unassisted.

360º rotating tray allows easy transition between feeding and

activity time. Activity tray features shape sorters, track toy with

glider beads, spinner ball and key teether.

4

3

2

1

Only use for children who are able to hold their head up unassisted (approximately 4 months of age). Stop using as a Posi�oner/Support Seat and Ac�vity Seat when child can walk or get in and out of product by themselves (approximately 12 months of age).

!Only use for children who can sit up unassisted.

!

! WARNING: When seat is used on adult chair, use only the feeding tray. Remove the ac�vity tray sec�ons.

Summer Infant (USA), Inc.1275 Park East Drive

Woonsocket, RI 02895 USA 401-671-6551

© 2020 Summer Infant, Inc.

Summer Infant stands behind all of its products. If you are not completely satisfied or have any

questions, please contact our Consumer Relations Team at 401-671-6551 or

www.summerinfant.com/contact

cleaning & maintenance:

• Fabric Seat & Support Insert: Machine wash, cold water, gentle cycle, no bleach. Tumble dry, low heat.

• Wipe frame with a damp cloth and mild soap.• Do not use if any components are damaged missing, broken,

or disassembled.

Pull the

lever beneath

the feeding tray

to release.

remove tray:

attach to adult chair:

x 4

MThread the

adult chair straps (M)

into the slots on the

underside of the

seat base.

1

Note: Pull up to ensure the straps are fully inserted. They should not pull out of the slots.

!

6Remove insert &

fabric seat

from restraint

straps.

5

Remove the

two T-straps from the

slots underneath

the seat.

x 2

x 3

4

Remove the

three T-straps from the

slots on the backrest.

removing fabric seat:removing fabric seat:removing fabric seat:

Remove the

four fasteners

from the keyhole

slots on the front

of the seat base

by sliding out.

x 2

3

x 2

Pull up the

two fasteners

on the underside

of the fabric seat

by lifting them up

and out from the

seat base.

x 22

Remove the feeding

and activity trays.1

storing adult chair straps:

child restraint:

Once fully assembled,

a storage pocket is located

underneath the front of the

seat. This pocket is used

to store the adult chair

straps. Coil straps

and insert.

Insert. Press to

release.

attach to adult chair (cont.):

fasten clips

around

chair back and

underneath chair

seat!

2

be sure to

tighten straps!

press in

to release

Never use on an adult chair without securely fastening chair straps. Always tighten adult chair straps and test security before use.

IMPORTANT

13 14 15

9 10 11 12