cpe: customer premise equipment. cpe = customer premise equipment components of cpe: dish antenna...

9
CPE: Customer Premise Equipment

Upload: collin-alexander

Post on 24-Dec-2015

225 views

Category:

Documents


3 download

TRANSCRIPT

Page 1: CPE: Customer Premise Equipment. CPE = Customer Premise Equipment Components of CPE: Dish Antenna – 1 LNBF - 1 Cable Wire-10 meters free during installation

CPE: Customer Premise Equipment

Page 2: CPE: Customer Premise Equipment. CPE = Customer Premise Equipment Components of CPE: Dish Antenna – 1 LNBF - 1 Cable Wire-10 meters free during installation

CPE = Customer Premise Equipment

Components of CPE:

• Dish Antenna – 1

• LNBF - 1

• Cable Wire-10 meters free during installation

• STB-1

• VC-1

• Remote and Audio video cable-1

• Connectors-1 Set

• User Manual Guide- 1

Below mentioned hardware is provided with each new connection

Page 3: CPE: Customer Premise Equipment. CPE = Customer Premise Equipment Components of CPE: Dish Antenna – 1 LNBF - 1 Cable Wire-10 meters free during installation

CPE - Dish Antenna

Direction of Antenna - It should be installed at 95 degree South East and 45 degree vertical.

Radius of Antenna- The radius of Antenna is 30 cm

Dish Antenna

LNBF – stands for Low Noise Block Filter

It accumulates signals from satellite and sends to STB through cable

CPE - LNBF (Low Noise Block Filter)

LNBF

Page 4: CPE: Customer Premise Equipment. CPE = Customer Premise Equipment Components of CPE: Dish Antenna – 1 LNBF - 1 Cable Wire-10 meters free during installation

STB (Set Top Box) – Standard Definition, Non recorder.

Set Top Box

STB It filters all the signals from dish antenna and synchronize with VC.

Model →Arion, AF- 5012S

Parameters ↓Type Zapper MPEG-2 , SD, DVB-SVendor ArionOn/ Stand-by YesChannel Up/ Down YesUSB Slot NAHDMI Connectivity NoS/P DIF out NAExtended IR NAConditional Access (Embedded CONAX)

1 Smart Card Reader Slot - Front Panel

CI Module (PCMCIA) Yes- 1 Slot - Front PanelVideo out CVBS RCA x 1

Audio out Analog RCA x 2 (L-CH x 1, R-CH x 1)Component video No

Power Supply(Input voltage) AC 90V-300V, 50Hz/60HzTuner Input connector 1xF type with loop throughTuner Output connector 1xF type IF Signal Out

Page 5: CPE: Customer Premise Equipment. CPE = Customer Premise Equipment Components of CPE: Dish Antenna – 1 LNBF - 1 Cable Wire-10 meters free during installation

VC (Viewing Card)

This card is just like a SIM card of mobile phone. To receive Zing signals, this card needs to be activated after installation. Every VC is uniquly numbered. This number is of 11 digits followed by a hyphen and 1 digit after that. You can locate this on your VC

Note -: STB and VC works only when both are paired with each other

Golden Chip

VC Number

Page 6: CPE: Customer Premise Equipment. CPE = Customer Premise Equipment Components of CPE: Dish Antenna – 1 LNBF - 1 Cable Wire-10 meters free during installation

Connecting Cable

• Used to connect equipment's such as STB, LNBF and Cable wire.

• Audio- Video Cable Provide with every connection

Page 7: CPE: Customer Premise Equipment. CPE = Customer Premise Equipment Components of CPE: Dish Antenna – 1 LNBF - 1 Cable Wire-10 meters free during installation

Remote

Remote Batteries

A remote is provided with 2 batteries

Page 8: CPE: Customer Premise Equipment. CPE = Customer Premise Equipment Components of CPE: Dish Antenna – 1 LNBF - 1 Cable Wire-10 meters free during installation

User Manual

User manual guides customer to use CPE

Manual guide helps to operate the STB and Zing Remote functions

Page 9: CPE: Customer Premise Equipment. CPE = Customer Premise Equipment Components of CPE: Dish Antenna – 1 LNBF - 1 Cable Wire-10 meters free during installation

Warranty

12Months

Only on Set top box and Viewing Card