configuring v200 for voip internode settings. - … · configuring v200 for voip internode...
TRANSCRIPT
Co nfig ur ing V200 for VoI P Internode Sett ings.
1. Navigate to ht tp :// 1 92 . 168 .3 0 . 1 in a web browser.
2. Enter “admin” for both username and password when prompted.(without quotes).
3. The main configuration page of the router will open. Now click on SIP on your
left hand side.
4. Now click on “configure” and then type in the following information.
Phone Number Internode VoIP account phone
number Display Number Internode VoIP account phone
number Auth.ID Internode VoIP account phone
number Auth. Password Internode VoIP account password
Confirm Password Internode VoIP account password
Expire 900
QValue 0.8
RTP packet interval 40
Codec G729 (from drop down menu)
DTMF rfc2833 (from drop down menu)
Payload type 101
Use proxy Yes (from drop down menu)
Host Address sip.internode.on.net
Port 5060
Domain sip.internode.on.net
5. Now click “Apply” at the bottom.
6. Click on “Save” on to your left, it will save all the setting you have done.
7. Then click on “Reboot”, it will reboot your router. After rebooting it will
show you the status of the SIP proxy or “Register Status”. If the Register
Status states “Registered Success” you should now be able to use your
Internode VoIP service.