compression calibration adapters for load cells
TRANSCRIPT
2 Piece Top block -to interface with theDiameter of the yoke’s ball seat -Retaining ring to interface with the Diameter of the compression top
Select an alignment which matches the outer diameter of the compression top
Attach retaining ring to the loading block as shown
Place the load cell on the alignment plate -Do not use alignment plug in the bottom of the load cell
Place the assembled load block on top of the load cell
Adjust the height-Align loading block, allowing yoke
to center load through the load cell
Apply Load
• Want to order these compression adapters and improve your force calibrations?
Contact us at [email protected] or Call 717-843-0081