compensator eliminator #4513 - fileburstvulcanworks.fileburst.com/inst/4513_compensator... ·...
TRANSCRIPT
![Page 1: Compensator Eliminator #4513 - Fileburstvulcanworks.fileburst.com/inst/4513_compensator... · 2015-08-24 · Compensator Eliminator #4513 603-668-6315 Manufactured by Motorway Engineering](https://reader030.vdocuments.mx/reader030/viewer/2022040202/5e777766fd7dbd7dca6c56e9/html5/thumbnails/1.jpg)
Compensator Eliminator #4513WWW.VULCANWORKS.NET603-668-6315
Manufactured byMotorway Engineering
85 Hancock St. Manchester, NH, 03101USA
Bend one of the tabs back and slide out all of the belleville springs
*Remove Primary Cover
*Remove Compensator Bolt
*Remove Clutch Hub, Chain and Compensator together.
This step is optional, but leaving the spring pack in may cause noise and/or an imbal-ance.
*Slide Alternator Rotor off shaft
Instructions for most 2006-10 Bikes with stock style compensator shown to the right.
![Page 2: Compensator Eliminator #4513 - Fileburstvulcanworks.fileburst.com/inst/4513_compensator... · 2015-08-24 · Compensator Eliminator #4513 603-668-6315 Manufactured by Motorway Engineering](https://reader030.vdocuments.mx/reader030/viewer/2022040202/5e777766fd7dbd7dca6c56e9/html5/thumbnails/2.jpg)
WWW.VULCANWORKS.NET603-668-6315
• Important: Refer to the Ser-vice Manual for your bike for a complete installation proce-dure.
• The Motor sprocket, Chain and Clutch hub must be installed at the same time.
• Install Bolt with red Loctite and included washer(Recessed Side toward Motor).
• Torque To 140-165 FT-Lbs
Springs Removed
• Mount Alternator Rotor back on shaft
![Page 3: Compensator Eliminator #4513 - Fileburstvulcanworks.fileburst.com/inst/4513_compensator... · 2015-08-24 · Compensator Eliminator #4513 603-668-6315 Manufactured by Motorway Engineering](https://reader030.vdocuments.mx/reader030/viewer/2022040202/5e777766fd7dbd7dca6c56e9/html5/thumbnails/3.jpg)
Instructions for most 2010-up Bikes with Screaming Eagle style compensator shown
to the right.
WWW.VULCANWORKS.NET603-668-6315
*Remove Primary Cover
*Remove Compensator Bolt
*Remove Clutch Hub, Chain and Compensator together.
• Important: Refer to the Service Manual for your bike for a complete installation procedure.
• Install included Large Washer onto motor sprocket shaft.
•• The Motor sprocket, Chain and
Clutch hub must be installed at the same time.
• Install Bolt with red Loctite and included washer(Recessed Side toward Motor).
• Torque To 145-165 FT-Lbs