compare these features 371, 372 & 373 series …model 373 pump performance curve models...

2
SECTION: 2.60.107 FM2522 0413 Supersedes 0109 COMPARE THESE FEATURES Cast iron motor & pump housing with corrosion- resistant powder coated epoxy finish Motor - 60 Hz, oil-filled, hermetically sealed, automatic reset thermal overload protected Permanently lubricated upper and lower bearings Stainless steel screws and handle No sheet metal parts to rust or corrode No screens to clog Glass-filled, engineered plastic non-clogging vortex impeller with metal insert Watertight neoprene "" ring between motor and pump housing 20 ft. UL Listed power cord with molded 3-wire plug Silicon Carbide/Carbon shaft seal Entire unit pressure tested after assembly Maximum temperature for effluent or dewatering—130°F (54°C) 1½" NPT Discharge COMPLETELY SUBMERSIBLE HERMETICALLY SEALED Watertight - dust tight 371, 372 & 373 SERIES (For Pump Prefix Identification see News & Views 0052) CONTINUOUS DUTY “EVAPORATIVE COOLING PUMPS” SUBMERSIBLE PUMPS FOR DEWATERING OR EFFLUENT EVAPORATIVE COOLING PUMPS FOR POULTRY APPLICATIONS © Copyright 2013 Zoeller Co. All rights reserved. Product information presented here reflects conditions at time of publication. Consult factory regarding discrepan- cies or inconsistencies. MAIL TO: P.O. BOX 16347 • Louisville, KY 40256-0347 SHIP TO: 3649 Cane Run Road • Louisville, KY 40211-1961 (502) 778-2731 • 1 (800) 928-PUMP • FAX (502) 774-3624 visit our web site: www.zoeller.com Manufacturers of . . . VORTEX TYPE IMPELLER Model 373 Shown R (Tested to UL778 and CSA22.2 108 Standards) MODELS AVAILABLE “371” - .3 HP, 115V or 230V 1 Ph, 1550 RPM “372” - 1 /3 HP, 115V or 230V 1 Ph, 3450 RPM “373” - .4 HP, 115V or 230V 1 Ph, 3450 RPM

Upload: others

Post on 12-Jul-2020

3 views

Category:

Documents


0 download

TRANSCRIPT

Page 1: COMPARE THESE FEATURES 371, 372 & 373 SERIES …model 373 pump performance curve models 371/372/373 0 40 80 120 160 200 240 10 20 30 40 50 60 70 0 5 2 4 6 8 10 35 30 25 20 15 10 flow

SECTION: 2.60.107FM2522

0413Supersedes

0109

COMPARE THESE FEATURES

• Cast iron motor & pump housing with corrosion-resistant powder coated epoxy finish

• Motor - 60 Hz, oil-filled, hermetically sealed, automatic reset thermal overload protected

• Permanently lubricated upper and lower bearings

• Stainless steel screws and handle• No sheet metal parts to rust or corrode• No screens to clog• Glass-filled, engineered plastic non-clogging

vortex impeller with metal insert• Watertight neoprene "" ring between motor

and pump housing• 20 ft. UL Listed power cord with molded

3-wire plug• Silicon Carbide/Carbon shaft seal• Entire unit pressure tested after assembly• Maximum temperature for effluent or

dewatering—130°F (54°C)• 1½" NPT Discharge

COMPLETELY SUBMERSIBLEHERMETICALLY SEALEDWatertight - dust tight

371, 372 & 373 SERIES(For Pump Prefix Identification see News & Views 0052)

CONTINUOUS DUTY

“EVAPORATIVE COOLING PUMPS”SUBMERSIBLE PUMPS FOR DEWATERING

OREFFLUENT EVAPORATIVE COOLING

PUMPS FOR POULTRY APPLICATIONS

© Copyright 2013 Zoeller Co. All rights reserved.

Product information presented here reflects conditions at time of publication. Consult factory regarding discrepan-cies or inconsistencies. MAIL TO: P.O. BOX 16347 • Louisville, KY 40256-0347

SHIP TO: 3649 Cane Run Road • Louisville, KY 40211-1961(502) 778-2731 • 1 (800) 928-PUMP • FAX (502) 774-3624

visit our web site:www.zoeller.com

Manufacturers of . . .

VORTEX TYPE IMPELLER

Model 373 Shown

R

(Tested to UL778 andCSA22.2 108 Standards)

MODELS AVAILABLE• “371” - .3 HP, 115V or 230V 1 Ph, 1550 RPM• “372” - 1/3 HP, 115V or 230V 1 Ph, 3450 RPM• “373” - .4 HP, 115V or 230V 1 Ph, 3450 RPM

Page 2: COMPARE THESE FEATURES 371, 372 & 373 SERIES …model 373 pump performance curve models 371/372/373 0 40 80 120 160 200 240 10 20 30 40 50 60 70 0 5 2 4 6 8 10 35 30 25 20 15 10 flow

RESERVE POWERED DESIGNFor unusual conditions a reserve safety factor is engineered into the design of every Zoeller pump.

CAUTIONAll installation of controls, protection devices and wiring should be done by a qualified licensed electrician. All electrical and safety codes should be followed including the most recent National Electrical Code (NEC) and the Occupational Safety and Health Act (OSHA).

For information on additional Zoeller products refer to catalog on Piggyback Variable Level Float Switches, FM0477; Electrical Alternator, FM0486; Mechanical Alternator, FM0495; Sump/Sewage Basins, FM0487; and Single Phase Simplex Pump Control/Alarm Systems, FM0732.

© Copyright 2013 Zoeller Co. All rights reserved.

019748

1 1/2" NPT

10 1/16

3 1/16

3 7/8

3 7/8

4 5/8

6 3/163 7/8

SK1014

MODEL 371

SK2064

1 1/2" NPT

12 1/8

5 3/8

3 7/8

6 7/32

4 5/8

3 7/8

3 7/8

MODEL 372 &MODEL 373

PUMP PERFORMANCE CURVEMODELS 371/372/373

0 40 80 120 160 200 240

706050403020100

52

4

6

8

1035

30

25

20

15

10

FLOW PER MINUTE

GALLONSLITERS

TOTA

L DY

NAM

IC H

EAD

4012

MET

ERS

FEET

373371 372

TOTAL DYNAMIC HEAD/FLOWPER MINUTE

EFFLUENT AND DEWATERING

MODELFeet

Shut-off Head:

371Meters Gal. Liters

5101520 6.1

4.63.01.5

193443

72129163

19.25 ft (5.9 m)

373Liters

615344

69Gal.

167

231201

261

38 ft (11.6 m)

2530 23 87

12934----

----

-- --7.69.1

372LitersGal.

30 ft (9.1 m)-- --

384550

144170189

1629

61110

Single Seal Control SelectionPart No. Volts Phase Mode Amps371-0002 115 1 Nonautomatic 9.7371-0004 230 1 Nonautomatic 4.8372-0002 115 1 Nonautomatic 6.0372-0004 230 1 Nonautomatic 3.2373-0002 115 1 Nonautomatic 8.5373-0004 230 1 Nonautomatic 4.3