collection of in-stack no2/nox ratio information

12
Collection of In-stack NO 2 /NO X Ratio Information March 14, 2012 Dan Dix Technical Leader [email protected] (610) 933-5246, extension 18

Upload: all4-inc

Post on 25-May-2015

1.378 views

Category:

Technology


2 download

TRANSCRIPT

Page 1: Collection of In-Stack NO2/NOx Ratio Information

Collection of In-stack NO2/NOX Ratio Information

March 14, 2012

Dan DixTechnical [email protected]

(610) 933-5246, extension 18

Page 2: Collection of In-Stack NO2/NOx Ratio Information

2

Introduction The collection of in-stack NO2/NOX data for

use in AERMOD’s OLM and PVMRM option has become more important since the promulgation of the new 1-hour NO2 NAAQS.

Many facilities are currently collecting NOX data using CEMS

CEMS collecting NOX data use the Chemiluminescence method which also measures NO and NO2.

Page 3: Collection of In-Stack NO2/NOx Ratio Information

3

Agenda Project Overview Current Setup Equipment Conclusions and Additional

Considerations Questions?

Page 4: Collection of In-Stack NO2/NOx Ratio Information

4

Project Conducting exploratory 1-hour NO2

and SO2 NAAQS air quality modeling for a cement facility.

NO2 NAAQS results showed issues when using Tier III method with OLM and default in-stack NO2/NOX ratio (0.5).

Determine site specific in-stack NO2/NOX ratio data using existing NOX monitor.

Page 5: Collection of In-Stack NO2/NOx Ratio Information

5

Current Setup Thermo Scientific Model 42i

Chemiluminescence NO-NO2-NOX

System currently collects NOX data on their DAHS and PLCs.

Page 6: Collection of In-Stack NO2/NOx Ratio Information

6

Chemiluminescence The Chemiluminescence process:

NO + O3 NO2 + O2 + hv

NO and O3 react to produce a characteristic luminescence with an intensity linearly proportional to NO concentrations.

Page 7: Collection of In-Stack NO2/NOx Ratio Information

7

42i Flow Schematic

Page 8: Collection of In-Stack NO2/NOx Ratio Information

8

Collecting Data Its was easier and more cost

effective to install a temporary datalogger than set up NO2 readings in their current DAHS and PLC Systems.

A Campbell Scientific CR1000 datalogger was hooked up to unused ports on the 42i and programmed to take 1 minute readings of NO, NO2, and NOX.

Page 9: Collection of In-Stack NO2/NOx Ratio Information

9

Equipment Setup

Page 10: Collection of In-Stack NO2/NOx Ratio Information

10

Results

Page 11: Collection of In-Stack NO2/NOx Ratio Information

11

Conclusions and Considerations

Cost effective and simple (less invasive) way to collect in-stack NO2/NOX information for use modeling NO2 using AERMOD’s OLM or PVMRM options.

Many facilities currently operate NOX CEMS under a variety of programs.

DAHS systems could also be set up to collect this information.

If no NOX CEMS is in place this data can also be collected during NOX testing.

Protocol Considerations• Statistical Analysis• QA/QC

Page 12: Collection of In-Stack NO2/NOx Ratio Information

12

Questions?

Dan [email protected]

(610) 933-5246, extension 18

2393 Kimberton RoadKimberton, PA 19442

All4 Inc.www.all4inc.com