cleaning shower system · · 2016-04-13wetting power (complete spreading ... use a freeze spray...
TRANSCRIPT
Equipment used Cleaning products Cleaning methods
FLO
OR
S
Manual cleaning
Alkaline detergent
• Damp sweeping• Manual cleaning with a scrubbing brush• Recovery of solied water with a flat mop
• Rinsing with clean water
Mechanical cleaning
or
if soiled
• Damp sweeping• Mechanical washing at 300-450 rpm
(with water recovery)
Manual cleaningNeutral detergent
Desinfectant detergent (1)
• Damp sweeping• Manual washing with flat mop
• Rinsing
Mechanical cleaning • Steam cleaning
Manual cleaning
Alkaline detergent
• Damp sweeping• Manual cleaning with a scrubbing brush• Recovery of solied water with a flat mop
• Rinsing with clean water
Mechanical cleaning• Damp sweeping
• Mechanical washing at 300-450 rpm (with water recovery)
WAL
LS (2
)
Cleaning of walls Neutral detergent • Wall washing• Rinsing
First use
Daily cleaning
Deep cleaning
*Neutre / **Alcalin
These cleaning instructions have to be adapted depending on traffic and location of the area.
(1) In areas where disinfection is essential (e.g. operating theatres, hospital rooms, etc.), alternate between using neutral detergent and amine-free disinfectant detergent.
(2) For further informations, please refer to page 2.
OR
OR
OR
CLEANING SHOWER SYSTEMELEGANCE SD / TARASAFE ULTRA H2O / MURAL CALYPSO
Manual washing equipment Disposable microfibre mop or gauze
Mechanical cleaning disk3M (or equivalent) colour disks
Damp sweeping equipmentFlexible mop preferably fitted with disposable, antistatic and/or pre-impregnated gauze strips
Mechanical cleaning equipmentAuto scrubber, rotocleaner or single-brush machine
Steam cleaning equipmentFollow the manufacturer’s recommendations
Manual scrubbing equipmentScrubbing brush
In the case of manual maintenance and to offer you the best results in terms of hygiene and appearance, Gerflor recommends that you use neutral and alkaline detergents with high wetting power (complete spreading and cleaning of the entire floor surface).
Here is a non-exhaustive list of products recommended by the main manufacturers:
KIEHL : Profloor*, RS Nett** TANA / WERNER : Green care SR15*, Floor Cleaner S*, Clean Fresh*, Difotan*, Clean Extreme*, Innomat**
ECOLAB : Brial Clean S* ANIOS : Deterg’anios* ROCHEX : Polystar*, Roctonic** BUZIL : HC 43** Dr. SCHUTZ : PU Reiniger**
DIVERSEY / SEALED AIR: Asset* DREITURM : Multinetzer*, Goldreif (vert)*, Linorein**, D1 Neu**
*Neutral / **Alkaline
Equipment used Cleaning products Cleaning methods
Alkaline detergent
• Manual cleaning with an alkaline detergent + sponge without abrasive• Recovery of water with a microfibre
disposable mop• Rinsing with clear water
Once a day Neutral detergentor disinfectant detergent
• Manual cleaning with a sponge without abrasive + neutral detergent for the
surfaces located in areas 1 or 2 and a disinfectant detergent for the surfaces
located in areas 3 and 4 and eventually in area 2
or • Steam cleaning
Once a month and at patient’s departure in areas 1 and 2
Once a week and at patient’s departure in areas 3 and 4
Disinfectant detergent
• Manual cleaning with a disinfectant detergent (without amine) and a sponge
without abrasive or
• Steam cleaning (if manual daily maintenance)
Once a month Alkaline detergent• Manual cleaning with an alkaline
detergent + a sponge without abrasive• Rinsing with clear water
*Neutre / **Alcalin
MAINTENANCE PROTOCOL FOR WALL COVERINGS
Manual washing equipment Disposable microfibre mop or gauze
Damp maintenance equipmentSponge without abrasive
Periodical cleaning
Deep cleaning
These cleaning instructions have to be adapted depending on traffic and location of the area.
without abrasive
without abrasive
without abrasive
without abrasive
MURAL CALYPSO / MURAL ULTRA / MURAL CLUB
First use
Daily cleaning
In the case of manual maintenance and to offer you the best results in terms of hygiene and appearance, Gerflor recommends that you use neutral and alkaline detergents with high wetting power (complete spreading and cleaning of the entire floor surface).
Here is a non-exhaustive list of products recommended by the main manufacturers:
KIEHL : Profloor*, RS Nett** TANA / WERNER : Green care SR15*, Floor Cleaner S*, Clean Fresh*, Difotan*, Clean Extreme*, Innomat**
ECOLAB : Brial Clean S* ANIOS : Deterg’anios* ROCHEX : Polystar*, Roctonic** BUZIL : HC 43** Dr. SCHUTZ : PU Reiniger**
DIVERSEY / SEALED AIR: Asset* DREITURM : Multinetzer*, Goldreif (vert)*, Linorein**, D1 Neu**
*Neutral / **Alkaline
STAIN REMOVAL
STAIN REMOVAL DURING WORKS
Rust Apply an anti-rust product or oxalic acid. Rinse thoroughly.
Food grease/paint/ballpoint pen/felt-tip pen/heavy grease (tar) Apply a solvent such as Essence C or White Spirit. Rub with undiluted product and rinse with plenty of water.
Rubber marks/Shoe marksApply an alkaline detergent (such as Dynatech Trophy) to shoe marks. Leave to act for 5 minutes. Rub.
Chewing-gum Use a freeze spray to harden the chewing gum, and then remove it with a plastic spatula (freeze sprays can be bought from cleaning product manufacturers or in pharmacies).
Paint mark removal • Do not use abrasive cleaning equipment (e.g. Scotch Brite, scouring pads, steel wool, etc.).• Use the solvent for the paint if known. If the solvent is not known, start with solvents such as
Essence C, White Spirit, etc. before trying stronger solvents such as Taraclean spray. If the stain proves hard to remove, do not persist.• Wipe and rinse the floor thoroughly after applying the solvent.
On paint dripsA freeze spray will yield excellent results when paint has formed a drip on the material (freeze sprays can be bought from cleaning product manufacturers or in pharmacies).
On adhesive marks • Fresh acrylic adhesive marks (< 1 month) Apply a water-based solution with added cleaning product, leave to act and mechanically clean and
rinse the floor.• Dried acrylic adhesive marks (> 1 month) Use Essence C or White Spirit. Wipe and rinse the floor thoroughly after applying the solvent.• Solvent adhesive marks Use strong solvents (such as Taraclean spray), but do not persist if the adhesive marks are difficult
to remove (as may happen with solvent-resistant cross-linked adhesives).
TIPS AND ADVICE FOR STAIN REMOVAL
• Never use abrasive disks or any procedure that risks damaging the surface treatment (abrasive products, solvents, etc.).
• Never use rubber caps (for chair legs or other furniture); instead, use PVC or Polyethylene caps.
PRECAUTIONS FOR USE