choose or draw a suitable a3 border sheet and start drawing. (do not draw the dimensions these are...
TRANSCRIPT
Choose or draw a suitable A3 border sheet and start drawing.(do not draw the dimensions these are for guidance only)
Use a 30/60 Set Square and a T Square to draw a construction line through the centre of the hexagon
S c a le 2 :1 D im : m mD r n : D a te :
M a tl.
Note : all dimensions +/- 1mm unless otherwise stated
Flip the Set Square and draw another construction line through the centre of the hexagon
S c a le 2 :1 D im : m mD r n : D a te :
M a tl.
Note : all dimensions +/- 1mm unless otherwise stated
Draw a vertical line 17mm from centre with the set square and T square
S c a le 2 :1 D im : m mD r n : D a te :
M a tl.
Note : all dimensions +/- 1mm unless otherwise stated
17mm
Use the Set Square again..
S c a le 2 :1 D im : m mD r n : D a te :
M a tl.
Note : all dimensions +/- 1mm unless otherwise stated
to complete one corner
S c a le 2 :1 D im : m mD r n : D a te :
M a tl.
Note : all dimensions +/- 1mm unless otherwise stated
Repeat this to get the other corners
S c a le 2 :1 D im : m mD rn : D a te :
M a tl.
Note : all dimensions +/- 1mm unless otherwise stated
Rub out the angled construction lines and thicken the hexagon outline.
S c a le 2 :1 D im : m mD r n : D a te :
M a tl.
Note : all dimensions +/- 1mm unless otherwise stated
Position the nut front view somewhere on the bolt.(this can be anywhere along the length of the bolt threaded section)
Trim the circle to make an arc and draw two more arcs in the positions shown on the nut and the bolt