ch. 8 multiplexing. 8.1 frequency-division multiplexing 8.2 synchronous time-division multiplexing...

Ch. 8 Multiplexing

Ch. 8 Multiplexing

• 8.1 Frequency-Division Multiplexing

• 8.2 Synchronous Time-Division Multiplexing

• 8.3 Cable Modems

• 8.4 Asymmetric Digital Subscriber Line

• 8.5 xDSL

• 8.6 Multiple Channel Access

8.1 Frequency-Division Multiplexing

• FDM--Definition

– The division of a transmission facility into two or more channels by splitting the frequency band transmitted by the facility into narrower bands, each of which is used to constitute a distinct channel.

8.1 Frequency Division Multiplexing (p.2)

• FDM-- Figure 8.3 – Incoming signals are each modulated using a

different carrier frequency (N sources.)– The channels are separated by guard bands,

which are unused portions of the spectrum.– The spectrum of the composite signal is shown

in Figure 8.3b.– The receiver consists of bandpass filters and

demodulators, centered around each carrier frequency.

8.1Frequency Division Multiplexing (p.3)

• Examples of FDM – Example 8.1Voiceband Signals

• 4 k Hz bandwidth (effective bandwidth 300 to 3400 Hz).

• SSBSC--single sideband, suppressed carrier.

• Use 64k Hz, 68k Hz, and 72k Hz carriers (Fig. 8-5).


• Analog Carrier Systems (Table 8.1)– FDM --earliest carrier system and still is common.– AT&T (North American Standard)

• Group--12 voice channels

• Supergroup--5 groups (60 voice channels)

• Mastergroup-10 supergroups (600 voice channels)


• Wavelength Division Multiplexing– Multiple beams of light are transmitted at

different frequencies on the same fiber.– 1997--Bell Labs demonstrated 100 beams each

operating at 10 G bps, for a total data rate of 1 trillion bits per second (1 terabit per sec).

– Commercial systems with 160 and 256 channels are currently available.

– Figure 8.5


• Problems with FDM carrier systems:– Crosstalk and intermodulation noise.– Must demodulate all signals for switching.– Inflexible.

8.2 Synchronous Time-Division Multiplexing

• STDM--Definition– A method of TDM in which time slots on a

shared transmission line are assigned to I/O channels on a fixed, predetermined basis.

– Each channel could carry a bit, byte, or block, depending on implementation.

– In general, start and stop bits are stripped off, if asynchronous terminals are being multiplexed.

– See Fig. 8.6.


• STDM Link Control– Blocks of bits are the input sources (eg. HDLC).– Flow control, error control, etc. will be handled

before and after the multiplexers.– Framing

• There is some framing required.

• Added-digit framing--a single bit is added to each frame; the bits will form a repetitive pattern.


• Pulse Stuffing– Suppose that the outgoing data rate of the

multiplexer, excluding framing bits, is higher than the sum of the maximum instantaneous incoming rates.


– Excess capacity is used by stuffing extra dummy bits or “pulses” into each incoming signal until its rate is raised to that of a locally-generated clock signal.

– Solves problems of synchronization among data sources.


• Example 8.3 --STDM-- (Fig.8.8)– Digital and Analog Sources

• Source 1 Analog– 2 kHz bandwidth (16 kbps).



• Sources 4-11: Digital– Each of the eight sources is a 7200 bps synchronous data

stream.


• Example 8.3 --STDM-- (Fig.8.8) (cont.)– Analog sources

• Sampled and encoded using 4 bits.

• Gathered into one 16-bit buffer .

• Result is a 64 k bps multiplexed information stream.

• Resulting analog source frame is Source 1 (4 bits), Source 2 (4 bits), Source 3 (4 bits), Source 2 (4 bits).

– Digital sources • Each is increased to 8 k bps using pulse stuffing.

– TDM signal: 64 k bps + 8 x 8 k bps =128 k bps.


• Digital Carrier Systems– Standards

• North American and ITU-T are different.• Table 8.3 (DS-1 through DS-4; Levels 1-5)


• DS-1 Transmission Format (Fig. 8-9)

– Frame Structure (193 bits)• 8 bits/channel• 24 channels • 1 framing bit.

– Data Rate• 193 bits/frame x 8 k frames/sec =1.544 Mbps.

8.2 Time Division Multiplexing (p.9)

• DS-1 Transmission Format (Fig. 8-9)(cont.)– Voice

• Uses bit robbing.– Every sixth frame has one bit "robbed" for

control signaling from each channel.– Data

• Bit 8 is used for control signaling (8,000 bps.)• Bit 1-7 used for 56 kbps service.• Bit 2-7 used for 9.6, 4.8, and 2.4 kbps service.


• SONET/SDH– An optical transmission interface.– Signal Hierarchy--Table 8.4.– Frame Formats--Fig.8.10 and 8.11.

8.3 Cable Modem• A device that allows the user to access the

Internet and other online services through a cable TV network.– Spectrum Division in North America

• User-to-network data (upstream): 5-40MHz

• Television Delivery (downstream): 50-550 Mz

• Network to user data (downstream: 550-750Mz

8.4 Asymmetric Digital Subscriber Line

• ADSL Design (Fig. 8.14)– ADSL provides more capacity down-stream than

upstream.– Although originally conceived for video-on-

demand, it is being used for Internet access.– Lowest 25kHz are reserved for voice (POTS)– Separate Upstream and Downstream (FDM).– Overlapping Upstream and Downstream (FDM

with echo cancellation.)– Discrete Multitone Transmission (DMT) is used.

8.5 xDSL

• ADSL is one of several schemes for high-speed transmission on a subscriber line.

• Other schemes are summarized in Table 8.8– High Data Rate Digital Subscriber Line– Single Line Digital Subscriber Line– Very High Data Rate Digital Subscriber Line

8.6 Multiple Channel Access

• Frequency Division Duplex– Two stations have a full duplex connection;

each station transmits in a different band.

• Time Division Duplex– Time compression multiplexing; data is

transmitted in one direction at a time.


• Frequency Division Multiple Access—spectrum is shared among multiple stations.– A base station can communicate with a group

of stations.– Satellite networks, cellular networks, WiFi, and

WiMAX.– Figure 8.19(a)


• TDMA—time division multiple access– Usually used with a base station, also.– Each sub-channel is dedicated and not shared.– See Fig. 8.19(b)

ch. 8 multiplexing. 8.1 frequency-division multiplexing 8.2 synchronous time-division multiplexing...

Documents

multiplexing slide

wavelength division

frequency band

framing bits

fdm carrier systems

multiple channel access

time slots

io channels