PIGGYBACK PROGRAMMING OF BFT MITTO REMOTE CONTROLSPIGGYBACK PROGRAMMING OF BFT MITTO REMOTE CONTROLSPIGGYBACK PROGRAMMING OF BFT MITTO REMOTE CONTROLSPIGGYBACK PROGRAMMING OF BFT MITTO REMOTE CONTROLS

Remotes with Hidden BuRemotes with Hidden BuRemotes with Hidden BuRemotes with Hidden Buttonttonttontton

Take remotes out to the gate or control board. You need to be near the installation.

With a remote that is already programmed to the gate.

Hold the hidden button in, on the back of the remote for 2 seconds (count 1000,2000)

Then hold the button on the front that is programmed to the gate, for 2 seconds (count

1000,2000)

Then with the new remote repeat above procedure.

Wait 10 seconds to go out of programming mode and the new remote should be

programmed.

*New Remotes with no hidden button*New Remotes with no hidden button*New Remotes with no hidden button*New Remotes with no hidden button

Instead of the hidden button you now use the 2 buttons on the front held down together

for the 2 seconds (count 1000,2000).

Note 4 button remotes you use the top 2 buttons.

MITTO 2 & 4 REMOTE CONTROL PROGRAMMINGMITTO 2 & 4 REMOTE CONTROL PROGRAMMINGMITTO 2 & 4 REMOTE CONTROL PROGRAMMINGMITTO 2 & 4 REMOTE CONTROL PROGRAMMING

Programming remotes with LCD displayed control boards

The control board has 3 buttons along the right side of the screen.

+ to scroll up menu, increase parameters and turn functions on.

- to scroll down, decrease parameters and turn functions

off.

OK to set program and to enter menus.

Press OK twice and then -scroll down to lingua (if language is displayed it is already

set to English skip next step) press ok and scroll down to eng ,press ok.

Then press + to radio and then press ok it will read (add start) press ok, it will read

(hidden button). Then with your remote either hold in the hidden button on the back of

the remote or if the remote does not have hidden button hold down the 2 buttons on the

front of the remote. The screen will then read (release) release buttons’ then hold the

button on the front of the remote that you wish to program.

The screen will then be OK 01 for the first remote 02 etc for each remote you program.

Wait 10 seconds and the remote will then work.

ProProProProgramming remotes with SW1 button on the control boardgramming remotes with SW1 button on the control boardgramming remotes with SW1 button on the control boardgramming remotes with SW1 button on the control board.

Hold the SW1 button in until led flashes.

Release.

Hold in the hidden button until led goes solid.

Release.

Hold in button you wish to program on the front of the remote.

Led will flash when programmed.

Program other remotes the same way. Wait 10 seconds for the receiver to go out of

program mode.

Remotes will now work.