band saws machines ds up to 330mm danobat - vigra · danobat arriaga kalea, 21 e-20870 elgoibar...
TRANSCRIPT
DS BAND SAW
BAND SAW
QUALITY AT YOUR SERVICEImprove your cutting process
D S B A N D S A W M A C H I N E
DANOBAT launches the DS horizontal cutting band saw machine, which is characterized by its accuracy and heavy construction, with the aim of ensuring productivity, extend the blade life and achieve the cutting quality needed.
The technical configuration of the DS band saw machine ensures the necessary mechanical conditions to implement the most advanced cutting techniques.
DANOBAT design with a fixed arm integrated into the sawhead and movable arm by means of a linear guide.
DS ENHANCED FEATURES, NEW DESIGN
It will help you to improve your business
MAIN CHARACTERISTICSBoth columns, the main round column and the secondary prismatic column, are designed to accept high blade tensions. The material is clamped on both sides of the blade, to reduce burrs on the cut component. The movable arm is automatically adjusted to the width of the material and is positioned in the optimum position in relation to the moving vice. This ensures that the bandsaw blade is supported as near as possible to the material on both sides of the cut.
DS 3A
Round mm inch
330 13“
Squaremm inch
330x330 13’’x13’’
Bundlesmm inch
330x210 13’’x8.3’’
Blade dimensionsmm inch
4970x34x1.1195”x1.3x0.04
Blade speedm/min
fpm14-90
46-295
Main motorkW hp
3 4
Weightkg lbs
1720 3792
GUIDING SYSTEMGuidance of the blade is done by a combination of bearings and hard metal plates fitted on plates holders, thus allowing any realignment of the blade position, the automatic arm avoids manual adjustments.
CONTROL PANEL AND SOFTWAREAll controls, both hydraulic and electrical, are ergonomically fitted in a single panel at one side of the machine.
The software allows the programming of different cut lengths of component from the same bar.
CHARIOTThe feeding charriott has a slow start and stop facility in addition to the normal feed to improve accuracy.
The feeding of the material by the moving vice is incremental thereby eliminating the need for the feeding vice to continuously move to the pre-set feed position.
This gives faster cycle times and helps reduce wear on the machine slides.
DANOBATArriaga kalea, 21E-20870 ELGOIBAR (Gipuzkoa) Spain
Tel.: + 34 943 74 81 50Fax: + 34 943 74 81 [email protected]
MORE INFORMATION ABOUT DANOBAT SAWING AND DRILLING SOLUTIONS AT
www.danobatgroup.comIf your mobile phone has the QR code reader tool you will be able to o directly to our site at www.danobatgroup.com Th
is d
ocum
ent i
s no
t a c
ontr
act.
DA
NO
BAT
rese
rves
the
right
of m
akin
g ch
ange
s to
all
mod
els
with
out p
rior n
otic
e. T
he il
lust
ratio
ns in
this
cat
alog
ue re
mai
n pr
oper
ty o
f DA
NO
BAT.
©D
AN
OBA
T 20
13
02/2
013
OTHER SAWING AND DRILLING SOLUTIONS:
3D plasma cutting
Drilling units
Mitre bandsaws
Vertical bandsaws
Thermal cutting & drilling