assembly instructions t table-tennis-tables.co · assembly instructions table-tennis-tables.co.uk t...
TRANSCRIPT
indoor / outdoor
ASSEMBLY INSTRUCTIONS
Table-Tennis-Tables.co.ukT
TT
GENERAL
Thank you for choosing the Teqball One table. We would like to give you some advice for the assembly. Please read and follow these instructions carefully.
SAFETY NOTICE
ASSEMBLY
The Teqball One table must be assembled by at least two adults following the numerical order of the assembly instructions. Before assembling, please check that all the proper parts are contained in the packages. The indicated quantities of parts make it possible to go through the assembly stages. Use the tools recommended on page 5.
IMPORTANT: Assembly should be carried out on a clean, dry, level surface. Please ensure there is nothing on the �oor that could scratch the tabletop. During the assembly put the packages to the ground and hold the parts above them to prevent the damage that is caused by falling or impact. During assembly remove the protection foil from the PMMA net and from the tabletop.
Any person handling or using the Teqball One table must follow the instructions as described in this document. The person in charge of assembling and using the Teqball One table must ensure that the recommendations for use given in this document and in the Owner's Manual of the Teqball One table are seen by all users. In communal use, it is strongly recommended that the instructions and diagrams are displayed.
Only use the Teqball One table after it has been fully assembled and after checking that the screws are tightened properly. Later, depending on frequency of use (but at least twice a month) check all screws regularly to ensure that their condition is good. The fasteners are coated with adhesive which is inactive until the coated fasteners are used. During assembly the adhesive is activated. The adhesive can prevent the self-loosening of fasteners, but the e�ect of the adhesive decreases with every assembly. Please do not remove the adhesive from the fasteners.
Assembly must be carried out at least by two adults during all stages.
2
ASSEMBLY REQUIRES AT LEAST 2 ADULTS!
TIGHTENING TOOL
TIGHTENING
TIGHTEN COMPLETELY STOP HALFWAY
KEEP THE TABLE HORIZONTAL
BE CAREFUL TO AVOID INJURIES! IF STUCK, TRY MOVINGTHE PARTS GENTLY!
3
3000
mm
1500 mm
147 kg
PLAYING SURFACEPACKAGE
118 kg
1620
1605
320
78 kg
2225 700
300
4
1x
1x
6
2x
1x
1x1x2x
1x
2x
2x
2x
M8x85
F1
F2
F3
F4
F5
M10x25M8x75
6x6x
8x
12x
D8M10x35
4x
C2
C1C3 C4
C5
C6
C7
C8
C9
purple blue(turquoise)
yellow green
5
6
8x
21
3 4
F4
!
!
!
!
C2 C2C3
C4
C1
C1
6
6
6
5
7 88/1
8/2
6
3x F5F2
3xF5F1
!
C5C6
C7
C6
C5
C8
7
6
6
3x 3x
109
11 124x F3
F5F13xF5
F23x
!
C8
C9
10/210/1
8
6
6
6
6
3x 3x
Remove the protection foil of the net and the tabletops
before assembly.
13
14
3xF5F1 6x
F5F2
3xF5F1
CHECK ALL FASTENERS!
9
6
6
15
DONE!
10
ENJOY TEQSPORTS!
11
Further information