Artemis Inside v. 01 Page 1 of 16

ARTEMIS INSIDE (HTC P3300)

This is not the guide on how to disassemble Artemis phone, but may help for people who wish to see what is inside. Equipment and tools you will need :

- Torex M-5 screwdriver - Set of small regular and philips screwdrivers - Cleaning tissues (or similar) - Tweezers - Plastic stick. This is something you make your own. When you will open body of the device, you will need

it to put in a gap to disassemble parts of device. You can use a wooden stick. !! Don’t do it with screwdriver or metal things, because you will scratch the body.

Artemis Inside v. 01 Page 2 of 16

1. Turn off the device. Disconnect charges, USB cables. It would be a good idea to cover screen of device to avoid scratches. It should be fine if you use protection film on your device.

2. Pull out the stylus.

3. Remove the battery and the micro SD card from your device.

Do not short battery pins, do not disassemble it. J

Artemis Inside v. 01 Page 3 of 16

4. Open the antenna cover with plastic stick, ~1 mm thick. Insert the stick between the body and antenna cover and turn it slightly. Be careful, don’t press or push too hard to avoid damage of fastening elements.

This part of antenna cover opens quite easy.

To completely remove the antenna cover, you can use wooden stick about 1.0mm - 1.5mm thick. You can use screwdriver, but carefully, not to leave scratches on the body of the device. Don’t pull antenna cover in vertical direction (see on the picture), because it will destroy clamping elements.

Artemis Inside v. 01 Page 4 of 16

To understand how clamping of the cover is organized, see picture below, this will help to avoid damage of these materials.

Artemis Inside v. 01 Page 5 of 16

Artemis Inside v. 01 Page 6 of 16

There are different antennas: for GSM, Wi-Fi, GPS.

Artemis Inside v. 01 Page 7 of 16

View on antennas from the other side.

5. Remove 4 screws to start disassembling the housing cover. You can see 2 of them on the picture below, 2 others on the rear side (not visible on this picture).

6. Start to disassemble the housing cover. You will need plastic stick for this. Insert the stick in a gap between front and rear cover of the device. Don’t push it too deep. Move the stick along the gap. Cover will unlock, but not completely.

Artemis Inside v. 01 Page 8 of 16

This is little difficult phase. There are 2 catches holding the cover. Please see picture below.

Artemis Inside v. 01 Page 9 of 16

Artemis Inside v. 01 Page 10 of 16

Artemis Inside v. 01 Page 11 of 16

7. Remove 4 screws holding motherboard.

8. Disconnect switch board and main board. Unlock the connector with small plastic stick and pull out the cable. Careful not to break the connector.

Artemis Inside v. 01 Page 12 of 16

9. Disconnect LCD screen. Unlock the connector with small plastic stick and pull out the cable. Careful not to break the connector.

Artemis Inside v. 01 Page 13 of 16

Artemis Inside v. 01 Page 14 of 16

10. There are some photos of motherboard.

Artemis Inside v. 01 Page 15 of 16

Artemis Inside v. 01 Page 16 of 16

I am sorry for photos and English. Photos may not be of good quality. It was late evening and actually not much light for taking pictures. I am not Englishman. J